Cutting Means Removal And Installation - Honda HRX537C Bedienungsanleitung

CUTTING MEANS REMOVAL AND
INSTALLATION
If you remove the cutting means for sharpening
or replacement, you will need a torque wrench
for installation. Wear heavy gloves to protect your hands.
CUTTING MEANS SHARPENING: To avoid weakening the cutting means, or
causing imbalance or poor cutting, the cutting means should be
sharpened by trained staff at an authorized Honda dealer.
CUTTING MEANS REPLACEMENT: Use Honda Genuine replacement cutting
means or their equivalent.
Removal
1. HYEA, VYEA types:
Put the throttle lever in the STOP position. Turn the fuel valve OFF and
disconnect the spark plug cap.
HZEA type:
Turn the key to the OFF position. Turn the fuel valve OFF and
disconnect the spark plug cap.
VKEA type:
Turn the fuel valve OFF and disconnect the spark plug cap.
2. Tilt the mower to the right so the fuel cap is up. This will help prevent
fuel leakage, motor oil seeping into the air filter, and hard starting.
HYEA, HZEA, VYEA types
[4]
[3]
[1] (2)
VKEA type
[3]
[1] (2)
[2] (2)
3. Use a 14 mm (6 point) socket wrench and remove the two
cutting-means bolts [1] and special washers [2] from the cutting-means
control assembly [5]. Use a wooden block to prevent the cutting means
from turning when removing the bolts.
4. Remove the upper [4] and lower cutting means [3].
16 EN
SAFETY
[2] (2)
[4]
[5]
Installation
B3 C19
1. Clean dirt and grass from around the cutting means mounting area.
D7 D8 D9
2. Install the cutting means [3] and [4] using the two cutting-means bolts
[1] and special washers [2] as shown.
Operating this mower with only one cutting means will result
in an improperly seated cutting means that can be thrown
from the mower and seriously hurt or kill someone.
Always use both cutting means as a set.
Be sure to install the special washers with the concave side toward the
cutting means and the convex side toward the head of the bolt.
The cutting-means bolts are specially designed for this application and
must not be replaced with other bolts.
[3]
[5]
3. Tighten the cutting-means bolts [3][4] with a torque wrench [5]. Use a
wooden block [6] to prevent the cutting means from turning.
[5]
49 ~ 59 N•m
Cutting-means bolt torque: 49 ~ 59 N·m
If you do not have a torque wrench, have an authorized Honda dealer
tighten the cutting-means bolts before you use the mower. If the
cutting-means bolts are overtightened, they could break. If the
cutting-means bolts are not tightened enough, they could loosen or
come out. In either case, it would be possible for the cutting means to
fly off while you are operating the mower.
Cutting-means Mounting Bolt Inspection
Inspect the cutting-means bolts for any signs of
damage or looseness. If they are damaged, they
must be replaced.
If they appear loose, a torque wrench must be
used to accurately tighten the cutting-means bolts
to the required torque. If you do not have a torque
wrench, take your lawnmower to an authorized
dealer to have the bolts replaced or tightened.
Use only Honda Genuine cutting-means bolts and
special washers, since they are specifically
designed for this purpose. Replacement part
numbers are on page 21.

WARNING
[2]
[3] [4]
[6]
Inspect washers and
bolt heads for looseness
[4]
[2] (2)
[1] (2)
and damage.