Automatic Setup-Mode - Selve commeo SEE-com Originalbetriebsanleitung

commeo initial operation/Setting by radio
Note for settings under point 5.2.: The motor must be selected for this setting with a trans-
mitter in SELECT mode (Status LED flashes slowly in orange). After completing the setting,
the motor is still selected (see 5.).

5.2.1. Automatic setup-mode

in operation bottom position, top stop/release
In delivery state the drive will, after the connection to the operating element, only execute a
moving interruption, which will be done twice at the first moving operation.
For the operation blocking springs/burglar proof fixations and fixed stoppers trailing edges
are mandatory.
Operation
click click
Drive
If the running direction of the drive corresponds to 'Up'
and 'Down' of the switch or setting switch, initial opera-
tion is completed.
Perform a test run: The drive stops automatically at the
end positions and performs a short release.
Otherwise, you can change the allocation of the moving
direction by a fast double-tap on the STOP button as
long as the transmitter is in SELECT mode.
The current assignment of the moving direction will be
taken over when
a) the SELECT mode will be left at an already pro-
grammed transmitter
or
b) by pushing the PROG button, the not programmed
transmitter will be assigned firmly.
Initial operation is completed. Perform a test run: The
drive stops automatically at the end positions and per-
forms a short release.
46