Herunterladen Inhalt Inhalt Diese Seite drucken

Manual Setup-Mode, Deletion And Manual Setting Of The End Positions - Selve commeo SEE-com Originalbetriebsanleitung

Inhaltsverzeichnis

Werbung

Verfügbare Sprachen
  • DE

Verfügbare Sprachen

  • DEUTSCH, seite 1
Setting of the end positions

4.5.3. Manual setup-mode, deletion and manual setting of the end positions

in operation bottom position, top stop/release
When the movement is interrupted once, the system is in manual setup-mode.
In manual setup-mode, the lower end position must be set and stored first. Afterwards, the
upper end position can be set and stored. Drive against the top stop until the motor is auto-
matically switched off.
Operation
Drive
E
6 s
E
E
3 s
E
Auto-Stop
Press the E button of the setting switch for 6 seconds. The
motor will switch to manual setting mode. Both limit positions
already set will be deleted.
Move the motor to the lower end position with the UP or
DOWN button.
Press the E button for 3 seconds.
The correct rotation direction assignment will be carried out at
the end of the end position setting.
Run against the limit stop at the top without stopping; the
motor stops automatically.
The end positions are now set and the rotation direction assign-
ment is correct. Perform a test run.
42

Werbung

Inhaltsverzeichnis
loading

Inhaltsverzeichnis