Package Contents; Electrical Safety - DeWalt D24000 Originalanweisungen

WARNING! Take care that the connections are dry before
activating the circuit and plugging in the machine.
-– Keep water clear off the electrical parts of the tool and away
from persons in the working area.
-– Replacement of supply cord shall always be carried out by
the manufacturer or his service agent.
-– WARNING! After voltage recovery set ON/OFF switch to off
before actuating RESET button of Residual Current Device
(RCD).
-– Ensure your installation is provided with suitable cut out of
"B" characteristic according to HD384.
Residual risks
The following risks are inherent to the use of these machines:
– injuries caused by touching the rotating parts
– injuries caused by disruption of the cutting disc
These risks are most evident:
– within the range of operation
– within the range of the rotating machine parts
In spite of the application of the relevant safety regulations and the
implementation of safety devices, certain residual risks cannot be avoided.
These are:
– Impairment of hearing.
– Risk of accidents caused by the uncovered parts of the rotating cutting
disc.
– Risk of injury when changing the disc.
– Risk of squeezing fi ngers when opening the guards.
Labels on tool
The following pictographs are shown on the tool:
Read the instruction manual before use.
Do not use recessed cutting discs.
Wear safety goggles.
Always wear regular working gloves while operating this tool.
Always wear ear protection.
Warning! Sharp edges.
On/off switch: position I (on) and 0 (off).
Carrying point
Do not place your hands within this area.
DATE CODE POSITION (FIG. B1)
The Date Code (78), which also includes the year of manufacture, is printed
into the housing.
Example:
Year of Manufacture
2010 XX XX

Package contents

The package contains:
1 Motor frame assembly
1 Support frame assembly
1 Water basin
1 Water pump
1 Cutting disc
1 Sliding table
1 Extension table
1 Edge guide
1 Rear water collector
1 Sliding table water collector
1 Small fl ange set
4 Hex screws
1 Hex key
1 Instruction manual
1 Exploded drawing
• Check for damage to the tool, parts or accessories which may have
occurred during transport.
• Take the time to thoroughly read and understand this manual prior to
operation.
Description (fi g. A)
Your D24000 tile saw has been designed for professional wet tile cutting
applications. Using the appropriate cutting disk, diameter 250 mm.,
it can cut concrete, brick, porcelain and ceramic materials. Providing
optimum versatility, the machine performs the cutting operations of straight
cutting (ripping), diagonal cutting, plunge cutting and bevel cutting easily,
accurately and safely.
This machine is not to be used for any operation other than those
mentioned in this manual.
1 On/off switch
2 Depth adjustment knob
3 Operating handle
4 Sliding table
5 Edge guide
6 Extension table
7 Water nozzles
8 Cutting disc
9 Guard
10 Depth stop
11 Bevel adjustment knob
12 Key storage
13 Water basin
14 Sliding table water collector
15 Rear water collector

Electrical Safety

The electric motor has been designed for one voltage only. Always check
that the power supply corresponds to the voltage on the rating plate.
Your tool is double insulated in accordance with EN 61029;
therefore no earth wire is required.
WARNING: 115 V units have to be operated via a fail-safe
isolating transformer with an earth screen between the primary
and secondary winding.
In case of cord replacement the tool must only be repaired by an authorized
service agent or by qualified electrician.
Mains Plug Replacement
(U.K. & Ireland only)
If a new mains plug needs to be fitted:
• Safely dispose of the old plug.
• Connect the brown lead to the live terminal in the plug.
E N G L I S H
35