Package Contents; Description (Fig. A); Assembly And Adjustment - DeWalt DE7187 Bedienungsanleitung

E N G L I S H
Safety instructions
Observe the safety regulations in the instruction
manual of the Power Tool to be connected to
this attachment. Also observe any applicable
additional safety rules. Read the following safety
instructions before attempting to operate this
product.
Keep these instructions in a safe place!
General
1 Keep work area clean
Cluttered areas and benches can cause accidents.
2 Keep children away
Do not let children come into contact with the
tool or extension cord. Supervision is required for
those under 16 years of age.
3 Use appropriate tool
The intended use is described in this instruction
manual. Do not force small tools or attachments
to do the job of a heavy-duty tool. The tool will
do the job better and safer at the rate for which it
was intended.
Warning! The use of any accessory or attachment
or performance of any operation with this tool,
other than those recommended in this instruction
manual may present a risk of personal injury.
Additional safety instructions for lasers
• This laser complies with class 2 according to
EN 60825-1:1994+A11. Do not replace a laser
diode with a different type. If damaged, have the
laser repaired by an authorised repair agent.
• Do not use the laser for any purpose other than
projecting laser lines.
An exposure of the eye to the beam of a class 2 laser
is considered safe for a maximum of 0.25 seconds.
Eyelid reflexes will normally provide adequate
protection. At distances over 1 m, the laser complies
with class 1 and thus is considered completely safe.
• Never look into the laser beam directly and
intentionally.
• Do not use optical tools to view the laser beam.
• Do not set up the tool at a position where the
laser beam can cross any person at head height.
• Do not let children come in contact with the laser.
18
Labels on attachment
The following pictographs are shown on the
attachment:
Read the instruction manual before use
Laser warning
Safety warning: class 2 laser

Package contents

The package contains:
1 Laser
1 Switch box
1 Torx wrench T20
1 Allen key 2.5 mm
1 Instruction manual
• Take the time to thoroughly read and understand
this manual prior to operation.

Description (fig. A)

Your DE7187 laser has been designed to project
laser lines to extend the capabilities of your D
mitre saw.
1 On/off switch
2 Switch box
3 Trigger lock
4 Allen key
5 Laser head

Assembly and adjustment

Do not mount this attachment to any
other machine than the D
DW716/DW718 mitre saw. Also refer to
the instruction manual of your power tool.
Installing the switch box (fig. A, B1 & B2)
Make sure that the power tool is
unplugged.
• Make sure that the on/off switch (1) is in the off
position.
• Loosen the screws (6) and remove them.
WALT
E
WALT
E