Package Contents; Assembly And Adjustments - DeWalt DCF6201 Übersetzung Der Originalanweisung

EngLIsh
• Risk of personal injury due to flying particles.
• Risk of burns due to accessories becoming hot
during operation.
• Risk of personal injury due to prolonged use.

Package Contents

The package contains:
1 Collated magazine attachment
1 PR2 collated screwdriver bit (DT7205-QZ)
1 Instruction manual
• Check for damage to the tool, parts or accessories which may
have occurred during transport.
• Take the time to thoroughly read and understand this manual
prior to operation.
Markings on Tool
The following pictograms are shown on the tool:
Read instruction manual before use.
Wear ear protection.
Wear eye protection.
Date Code Position
The date code, which also includes the year of manufacture, is
printed into the housing.
Example:
2018 XX XX
Year of Manufacture
Description (Fig. A)

WARNING: Never modify the power tool or any part of it.
Damage or personal injury could result.
Screw guide
1
Screw length adjustment
2
Fine depth adjustment
3
Advancing mechanism
4
Shoe
5
Advancing mechanism removal button
6
Release buttons
7
Collated screwdriver bit
8
Intended Use
This collated drywall magazine is a professional attachment
designed to be used with the DCF620 or DCF621 D
screwdriver for professional driving of collated screws.
DO nOt use under wet conditions or in the presence of
flammable liquids or gases.
DO nOt let children come into contact with the tool.
Supervision is required when inexperienced operators use
this tool.
12
• Young children and the infirm. This appliance is not
intended for use by young children or infirm persons
without supervision.
• This product is not intended for use by persons (including
children) suffering from diminished physical, sensory or
mental abilities; lack of experience, knowledge or skills
unless they are supervised by a person responsible for their
safety. Children should never be left alone with this product.

ASSEMBLY AND ADJUSTMENTS


WARNING: To reduce the risk of serious personal
injury, turn tool off and disconnect tool from power
source before making any adjustments or removing/
installing attachments or accessories. Be sure the
trigger switch is in the OFF position. An accidental start-up
can cause injury.
Fitting the Collated Screwdriver Bit (Fig. A, B)
NOTICE: For proper operation only use a D
screwdriver bit.
1. Remove the nose cone from the screwdriver.
2. Remove the mounted bit and bit holder from
the screwdriver.
nOtE: Refer to and follow all instructions on changing bits
and holders in your screwdriver manual.
3. Insert the provided collated screwdriving bit
holder until it clicks into place.
Installing and Removing the Magazine from
the Screwdriver (Fig. B)
With the the nose cone removed and provided driver bit
installed, push the magazine over the bit onto the screwdriver
until the magazine clicks into place and ensure that it does
not disengage.
nOtE: If necessary, rotate the attachment to locate properly
on mount.
nOtE: Make sure the screwdriver control lever is set to forward
rotation before use.
To remove the magazine, press and hold the release buttons
on both sides of the accessory and pull accessory off
the screwdriver.
OPERATION
Instructions for Use

WARNING: Always observe the safety instructions and
applicable regulations.

WARNING: To reduce the risk of serious personal
WALT
injury, turn tool off and disconnect tool from power
e
source before making any adjustments or removing/
installing attachments or accessories. Be sure the
trigger switch is in the OFF position. An accidental start-up
can cause injury.
WALT collated
e
8 into the bit
8
7