eta BARICELO Bedienungsanleitung Seite 35

Regularly inspect and clean all parts to prevent mould on coffee residues!
Coffee grinder (F)
Depending on the frequency of use, clean the coffee grinder regularly (we recommend at
least once a month). Remove upper part F1 (see Fig. 3) for easy maintenance. Clean the
grinder and its parts in a dry way. Shake out, blow out or use brush I to remove the coffee
powder on the surface of the components. Cover F4 can be washed in water with added
detergent (Allow to dry before using it again). Use the reverse procedure to assemble the
coffee grinder after maintenance.
Water tank (D)
We recommend that you clean the tank thoroughly and regularly (about once a week). Use
regular washing-up liquid and then rinse the tank with clean water. So as to prevent build-up of
scale deposits, we recommend that you also rinse the tank under running water once a day.
Aluminium lever (C)
Remove coffee grounds from the stainless steel bowls (C1, C2, C3, C4) after each use.
Rinse the funnel thoroughly under running water. Wash the filters (C1, C2, C3, C4) in warm
water with detergent and then rinse with clean water. Wipe the plastic handle with a damp
cloth. Then let everything dry.
Drip tray (E)
Pour the drip tray as required. Wash parts E and E1 with a conventional dishwashing
detergent, rinse with clean water and allow to dry.
Steam nozzle and hot water outlet (A3)
The nozzle must be cleaned after each use. You can do so by activating it and immersing
it in a container of clean water and then wiping it with a dry tissue. Also, periodically clean
it by removing it by removing its A5 orifice. If necessary, clean the mouth opening with
a cleaning needle G (or other suitable tool).
Hot water outlet (A6)
If the drain is contaminated with limescale, it must be removed (see Removing limescale).
For more thorough cleaning you can remove the A7 orifice.
Descaling
We recommend that you remove scale at least once a month. Scale may be removed by
means of a solution of water with preparation destined for these purposes (for example,
ETA518000201). Always follow the manufacturer's instructions for the product, which are
usually on the packaging. The procedure is as follows:
1. Place approx. 1 litre of prepared cleaning solution in tank D (a proportion of detergent
and water - according to the manufacturer's instruction).
2. Position lever C correctly.
3. Place a proper container under the coffee spout, steam nozzle and hot-water spout.
4. After heating up the coffee machine, press and hold buttons B1 a B4 (approx. 5 seconds)
simultaneously to switch the unit to descaling mode (Indicator lamp B6 will go on).
5. Set the steam knob A1 to the „
IMPORTANT
" position.
35 / 71
EN