Cleaning The Heat Exchanger - Qlima Eleonora 74-2 S-line Gebrauchsanweisung

man_Eleonora 74-2 S-line ('22) V1.indd 153 man_Eleonora 74-2 S-line ('22) V1.indd 153
5. Put the brazier and the ash drawer back into the stove. Make sure the bra-
zier is refitted correctly. Make sure the large opening is near the ignition
rod (as indicated in figures 19 & 20). If the brazier is refitted incorrectly, the
stove will not be lit.

6.5 CLEANING THE HEAT EXCHANGER

The heat exchanger needs to be cleaned daily with the help of a scraper. Make sure
the unit is switched off and the stove door closed. Move the scraper handle, which
is mounted on the outlet grille (see figure 21) forwards and then back. Repeat this
action 5 or 6 times until you no longer feel any resistance from the scraper.
6.6 CLEANING THE HEARTH
First clean the heat exchanger (see section 6.5, Cleaning the heat exchanger).
1. Remove the brazier and ash drawer. See section 6.4
2. Remove the heat shield located at the top of the stove.
a. Push the front of the heat shield upwards (figure 22) to release the fixing
points 2 (figure 23). Then pull the heat shield forwards to release fixing
point 1 (figure 23).
b. Push the rear of the heat shield down (figure 24).
c. Push the left side up in the direction of arrow 1 (figure 25) and turn the
right side downwards in the direction of arrow 2 (figure 25).
d. Then remove the heat shield from the combustion chamber.
3. Now remove the inner plates from the hearth.
a. Remove screws 1 and 2 (figure 26).
b. Use a screwdriver to pry the plating loose (figure 27).
c. Pull the plating forwards towards the door and remove it from the hearth.
Repeat for the plating on the right side (figures 28 and 29).
d. Remove the panel at the rear of the hearth by pulling it forward. Use a
screwdriver if necessary. Remove the panel from the stove (figure 30).
e. Remove the panels on the left and right sides. Slide the side panel about
2 cm forwards towards the door past the part marked with the arrow
(figure 31).
f. Now pull the top of the panel to the middle of the hearth and remove it
from the stove. Repeat this procedure to remove the panel on the right
side of stove from the hearth (figure 32).
g. Remove the base plate on the right. Pry it upwards with the aid of a
screwdriver and remove it from the stove (figure 33).
h. Remove the base plate on the left by sliding it horizontally 3 cm to the
right and then lifting it out of the hearth (figures 34 and 35).
4. Clean the hearth, the area beneath the brazier and the plating with a brush
and a vacuum cleaner.
5. After cleaning all the parts that have been removed, fit them back into the
hearth in reverse order.
6.7 CHECK THE SEAL ON THE FIRE DOOR
Check the door seal for leaks and damage at least twice a year; the first time before
the season starts. If necessary, have the door seal replaced by a Qlima-approved
technician. Only use original Qlima spare parts.
4
153
03-05-2022 16:27 03-05-2022 16:27