Setting The Temperature - Qlima Eleonora 74-2 S-line Gebrauchsanweisung

3.
man_Eleonora 74-2 S-line ('22) V1.indd 145 man_Eleonora 74-2 S-line ('22) V1.indd 145
automatically when the set temperature has been reached. See section 4.6
for further explanation of the operation and setting of Save mode.
4.3 NON-STANDARD START-UP PROCEDURE
When the stove starts at a room temperature that is lower than around 0ºC or
when the combustion air is lower than 0ºC, the start-up procedure may be differ-
ent.
When the combustion procedure at these lower temperatures does not result in a
properly burning fire, the display will show "ALAr No FirE".
To light the fire, place "firelighters" on the bottom of the brazier. Light the fire-
lighter with a match and wait 1 minute before lighting the stove using the "stand-
ard start-up procedure" as described in section 4.2.
If this does not result in a properly burning fire, the stoves setup parameters will
need to be changed by a professional. Contact a Qlima-approved fitter.

4.4 SETTING THE TEMPERATURE

1. Push button 1 to go to the temperature setting menu. The display will show
"set" and the desired temperature.
2. Press button 1 to reduce the desired temperature. The display will show set
temperature.
3. Press button 2 to raise the desired temperature. The display will show set
temperature.
4. The desired temperature has now been set. After 3 seconds, the display will
automatically return to normal operating mode.
5. The procedure for changing the temperature is now complete.
6. The desired temperature can also be set using the remote control. See sec-
tion 4.8 for instructions on using the remote control.
The desired temperature can be set anywhere between 7ºC and 40ºC.
4.5 CHANGING THE HEAT OUTPUT OF THE STOVE
1. Push button 2 once. The display will show "pot" and one of the 5 heat out-
put levels.
2. Push button 1 to reduce the heat output setting. The display will show the
new output setting.
3. Push button 2 to raise the heat output setting. The display will show the
new output setting.
4. Once the display has shown the new output setting, 3 seconds later the dis-
play will automatically return to normal operating mode.
4
145
03-05-2022 16:27 03-05-2022 16:27