Kessel Aqualift XL Basic Einbau- Und Betriebsanleitung Seite 27

Hang the end(s) of the chain(s) on the pre-mounted fas-
tening hooks in the upper section.
Use hook screws to fix the pump cable on the tank wall
2
and/or the upper section. Where possible, avoid contact
of the pump cable with water.
Use the pulling wire to draw the pump cable through the
cable conduit and connect as described in the enclosed
control unit instructions.
Hang the submersible pressure switch on the pre-
mounted suspension bracket, near the ball valves.
Draw the pressure hose through the cable conduit with a
continuous rising gradient to the control unit.
Close off the cable conduit at both ends, liquid and odour
tight.
The height of the submersible pressure switch is preset in
the factory and may not be adjusted.
016-285_01 Installation and operating instructions 27 / 52