Displaying And Deleting Measured Values - Beurer BM 28 Gebrauchsanweisung

The measured blood pressure value was
obtained when the user's circulatory system
was sufficiently at rest and reliably represents
the blood pressure at rest.
Indicates that the value was obtained when the
user's circulatory system was not sufficiently
at rest. The blood pressure values measured in
this case generally do not represent the blood
pressure at rest. The measurement should
therefore be repeated after a period of physical
and mental rest lasting at least 5 minutes.
No During the measurement it was not possible
resting to determine whether the user's circulatory
indicator system was sufficiently at rest. In this case too,
symbol is the measurement should be repeated after a
displayed period of rest lasting at least 5 minutes.
1
The user's circulatory system not being sufficiently at rest
can be the result of various factors, such as physical stress,
2
1
mental strain/distraction, speaking or experiencing cardiac
arrhythmia during the measurement.
2
In an overwhelming number of cases, HSD will give a very
good guide as to whether the user's circulatory system is
rested when a blood pressure measurement is taken.
However, certain patients suffering from cardiac arrhythmia
or chronic mental conditions may remain haemodynamical-
ly unstable even in the long-term, something which persists
even after repeated periods of rest. The accuracy of the re-
sults for the blood pressure at rest is reduced in these users.
Like any medical measurement method, the precision of HSD
is limited and it can lead to incorrect results in some cases.
Nevertheless, the blood pressure measurements taken when
the user's circulatory system is sufficiently at rest represent
particularly reliable results.
6.5 Displaying and deleting measured
values
The results of every successful measurement are stored to-
gether with the date and time. If there are more than 30 meas-
urements, the oldest measurements are lost.
• Press the memory button M. Select the desired user
memory ( ... ) by pressing the memory button M
again.
• If you press the function button +, the average value of
all the stored measured values in the user memory will be
displayed. If you press the function button + again, the
average value of the morning measurements for the last
7 days will be displayed (morning: 5 am – 9 am, display
). If you press the function button + again, the average
value of the evening measurements for the last 7 days
will be displayed (evening: 6 pm – 8 pm, display
you continue to press the function button +, the most
recent individual measured values are displayed in turn
with the date and time.
• To switch off, press the START/STOP button
• If you forget to switch off the device, it will switch itself off
automatically after 30 seconds.
32
). If
.