Warnings; Safety Instructions; Danger Due To Insufficient Personnel Qualification; Risk Of Injury From Pressurised Components - oventrop Multidis SF Betriebsanleitung

Multidis SF
Safety-related information
2.2

Warnings

Each warning contains the following elements:
Warning symbol
SIGNAL WORD
Type and source of danger!
Possible consequences if the danger occurs
or the warning is ignored.
!
Ways to avoid the danger.
Signal words define the severity of the danger
posed by a situation.
NOTICE
Indicates a situation that can potentially
result in damage to property if not avoided.
2.3

Safety instructions

We have developed this product in accordance
with current safety requirements.
Observe the following instructions for safe
use.
2.3.1 Danger due to insufficient personnel
qualification
Work on this product may only be carried out
by suitably qualified specialist tradespeople.
Due to their professional training and
experience as well as knowledge of the
relevant legal regulations, qualified specialist
tradespeople are able to carry out work on the
described product in a professional manner.
Operator
The operator must be instructed in the
operation by specialist tradespeople.
2.3.2 Risk of injury from pressurised
components
f
Only carry out work when the system is
depressurised.
f
Adhere to the permissible operating
pressures during operation.
18
2.3.3 Risk of burns due to uncontrolled
escape of hot media
f
Only carry out work on the heating/cooling
circuit when the system is depressurised.
f
Check that the product is not leaking after
work is complete.
f
Wear safety goggles.
2.3.4 Risk of burns on hot components and
surfaces
f
Allow the product to cool down before
working on it.
f
Wear suitable protective clothing to avoid
unprotected contact with hot fittings and
plant components.
2.3.5

Risk of injury from improper work

Stored energy, angular components, points
and corners on and in the product can cause
injuries.
f
Ensure there is sufficient space before
starting work.
f
Handle open or sharp-edged components
with care.
f
Keep the working area tidy and clean to
avoid sources of accidents.
2.3.6 Availability of the operating
instructions
Every person who works with this product
must have read and apply this manual and all
applicable instructions.
The instructions must be available at the place
of use of the product.
!
Pass on these instructions and all
applicable instructions to the operator.
140645281-V01.02.2022