Display Elements; Labeling - Balluff BNI PNT-508-105-Z067 Betriebsanleitung

BNI PNT-5_8-105-Z0_7
Network interface
4
Product description (continued)
4.3

Display elements

Fig. 4-3: Display elements
Port/Pin LEDs
– LED 00 – Port-Pin 4
– LED 01 – Port-Pin 2
Port/Pin LEDs Standard-Port
Signal Meaning
Off State of input or output pins is 0
Yellow State of input or output pins is 1
Both LEDs Short circuit of sensor supply between
flashing red pin 1 and pin 3
Red Short circuit at output on pin 2/4 against
pin 3
Red No high signal at diagnostic input
Red 24 V input signal on configured output
(actuator warning)
Tab. 4-1: LEDs Standard-Port
Port/Pin LEDs IO-Link-Port
Signal Meaning
Green IO-Link connection active
Flashing No IO-Link connection or incorrect
green IO-Link device
Green, fast IO-Link: Preoperate during data storage
flashing
Red, fast Validation failed / incorrect configuration
flashing of the IO-Link data length
Red, fast Data storage failed / incorrect device for
flashing data storage
Red IO-Link: Short circuit of pin 4 against
pin 3
Tab. 4-2: LEDs IO-Link-Port
8 english
Status LEDs
Port/Pin LEDs:
Status of IO-Link and
I/O-Ports
Status-LEDs
LED Signal Meaning
US Green Input voltage OK
Red flashing Input voltage low (< 18 V)
UA Green Output voltage OK
Red flashing Output voltage low (< 18 V)
Red No output voltage present
(< 11 V)
SF Off No error
Red Watchdog timeout; channel,
general or extended diagnostics
present; system error
Red flashing Service DCP signal started via
bus
BF Off No error
Red Low speed of physical link; or no
physical link
Red flashing No data exchange or no
configuration
100 Off Transmission rate: 10 Mbit/s
Yellow Transmission rate: 100 Mbit/s
XF1/2 Flashing Data transfer
green
Tab. 4-3: Status-LEDs
4.4

Labeling

Order code
Fig. 4-4: Labeling (example)
Type