6.
Maintenance of the power generator
The periods between maintenance work may vary from case to case depending on the importance
of the system as well as environmental and usage conditions. As a general rule, an initial inspection is
recommended after about 100 operating hours, but after one year at the latest. After this, it
should also be done whenever maintenance is performed on the drive engine. During maintenance
work, checks are made that:
•
the generator runs without any abnormal noise or vibrations which might lead to bearing da-
mage
•
the operating data are correct
•
the air inlet is not blocked
•
the connection cables show no signs of chafing
•
the electrical connections are securely attached
•
all the nuts and bolts are properly tightened.
6.1.
Maintenance of the drive engine
For maintenance on the drive engine, follow the maintenance plan in the operating manual of the
engine or have your authorised dealer carry out the necessary work.
f
UEL AND
f
UEL AND
Risk of serious injuries leading to death
•
•
•
•
•
•
Initiate life-saving emergency measures
H
OT
Risk of body parts being burnt or scalded
•
•
Cool the injured place
Provide first aid in accordance with guidelines, notify first responders
Used engine oil must be disposed of in an environmentally responsible manner. Used oil may neither
be put in amongst general waste nor poured into the sewer system, into a drain or on to the ground.
We recommend placing used oil in a sealed container and handing it to a recycling centre or a
Page 36
I
WARNING
f
v
H
f
UEL
ApOUrS ArE
IgHLy
LAMMAbLE
f
v
T
UEL
ApOUrS ArE
OXIC
Only refuel or handle fuel when the engine is stopped!
Never refuel near open flames, sparks or other sources of ignition.
No smoking!
Do not spill fuel! Immediately wipe up any drips!
Ensure good ventilation!
Wear protective gloves
I
CAUTION
E
p
H
O
M
NgINE
ArTS Or
OT
pErATINg
Allow the engine to cool down.
Wear protective gloves
NOTE
customer service centre for recycling.
/E
XpLOSIvE
ATErIALS