Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
E N
S E R V I C E
1 oil dipstick
2 oil filler cap with drain plug
High pressure pump
3
Check the pump on loose connections, bolts, seals and leaks.Check regularly
the oil level of the pump. If the oil level has decreased too much or pollution
of oil is observed, should these be replaced before working further. put the
machine on a horizontal base. The oil level must stand halfway the level glass.
Take at doubt the oil level stick separately, where the oil level must stand
between both mark lines. If pump oil gives a milky impression, frequently
indicates this on an internal leak as a result of which water touched oil there.
Immediately repair is necessary then.
High and low pressure part
4
Check the hoses, piping and connections on external damages and leaks.
If damaged or if leaks are present, these must be immediately replaced.
Spray tools
5
Check lances and guns on leaks, external damages and hair cracks. If damaged
or leaks these must be immediately replaced. Check the spray image of the
water jet, if these blows out to much you must replace the nozzle. Check
protective cap- nozzle on damages and replace if necessary. Check the thread
of the couplings on external damages. at damage let these replace without
delay.
Electrical part
6
Checks visible electric wiring and components (among other things switches)
on external visible damages. If damaged let replace the concerning parts.
Engine
7
Engine oil: check the oil level with the level stick (to see guide engine). oil
change: drain the oil while the engine is still warm to assure rapid and complete
draining. Remove the oil filler cap and drain plug to drain the oil. Install the drain
plug, and tighten it securely. Refill with the recommended oil and check the oil
level. Install the oil filler cap. oil capacity engine: 0.6 ltr.
Check the oil level of the reduction gear (if available).
air filter: check or there sits no clogging for the air opening.
Fuel filter: check on clogging and possibly clean or replaced.
Oil drainage high pressure pump
8
put a oil trough under the drain plug. Remove the drain plug.
let all the oil in the oil trough. assemble the drain plug (with a new packing ring).
Oil filling high pressure pump
9
Remove the oil-level gauge. Fill the crankcase with oil until the oil-level comes
up to the middle of the gauge (type oil see technical data). Check the oil-level
on the basis of the marks on the oil-level gauge. place back the oil- level gauge.
Carry away used oil
10
pour the tapped oil in a can. Deliver the tapped oil by your dealership or at the
proper authorities.
DiBO 22
1
2
Werbung
Inhaltsverzeichnis
