After Finishing Work; Transporting; Transporting The Chainsaw; Transporting The Battery - Stihl MSA 160 C Gebrauchsanleitung

12 After Finishing Work

► Shout a warning.
► With arms outstretched, cut through the hold‐
ing strap from outside at a downward angle.
The tree falls.
11.4.10 Felling a large diameter leaner
A leaner is felled with a felling cut and holding
strap. This felling cut must be performed if the
tree diameter is greater than the guide bar's
length.
► Shout a warning.
1.
3.
2.
► Apply the spiked bumper behind the holding
strap at the same height as the felling cut and
use it as a pivot.
► Hold the saw horizontally and swing it into the
felling cut as far as possible.
► Enlarge felling cut in direction of hinge.
► Enlarge felling cut in direction of holding strap.
► Move to the other side of the tree.
► Apply the spiked bumper behind the hinge at
the same height as the felling cut and use it as
a pivot.
► Hold the saw horizontally and swing it into the
felling cut as far as possible.
► Enlarge felling cut in direction of hinge.
► Enlarge felling cut in direction of holding strap.
0458-701-9621-C
► Shout a warning.
► With arms outstretched, cut through the hold‐
12 After Finishing Work
12.1
► Switch off the chain saw, engage the chain
► If the saw is wet: Allow the saw to dry.
► If the battery is wet: Allow the battery to dry.
► Clean the saw.
► Clean the bar and chain.
► Loosen the wingnut.
► Rotate the adjusting wheel two full turns coun‐
► Tighten down the wingnut.
► Fit the scabbard so that it completely covers
► Clean the battery.

13 Transporting

13.1
5.
6.
► switch off chain saw, engage chain brake and
4.
► Fit the chain scabbard so that it completely
Carrying the chainsaw
► Carry the chainsaw by holding the front handle
Carrying the chainsaw in a vehicle
► Secure the saw to prevent turnover and move‐
13.2
► Switch off the chain saw, engage the chain
► Make sure the battery is in a safe condition.
► Observe the following points when packing the
► Secure the packaging so that it cannot move.
The battery is subject to the requirements for the
transport of dangerous goods. The battery is
classified as UN 3480 (lithium-ion batteries) and
has been tested in accordance with UN Manual
of Tests and Criteria, Part III, sub-section 38.3.
ing strap from outside at a downward angle.
The tree falls.
After Finishing Work
brake and remove the battery.
terclockwise.
The chain is now slack.
the guide bar.

Transporting the Chainsaw

remove battery
covers the guide bar.
in your right hand with the guide bar pointing
to the rear.
ment.

Transporting the Battery

brake and remove the battery.
battery:
– The packaging must be non-conductive.
– Make sure the battery cannot shift inside the
packaging.
English
49