After Finishing Work; Transporting; Transporting The Chainsaw; Transporting The Battery - Stihl MSA 60.0 C Gebrauchsanleitung

English
► Shout a warning.
► With arms outstretched, cut through the hold‐
ing strap from outside at a downward angle.
The tree falls.
12.4.10 Felling a large diameter leaner
A leaner is felled with a felling cut and holding
strap. This felling cut must be performed if the
tree diameter is greater than the guide bar's
length.
► Shout a warning.
1
2 3
► Apply the spiked bumper behind the holding
strap at the same height as the felling cut and
use it as a pivot.
► Hold the saw horizontally and swing it into the
felling cut as far as possible.
► Enlarge felling cut in direction of hinge.
► Enlarge felling cut in direction of holding strap.
► Move to the other side of the tree.
► Apply the spiked bumper behind the hinge at
the same height as the felling cut and use it as
a pivot.
► Hold the saw horizontally and swing it into the
felling cut as far as possible.
► Enlarge felling cut in direction of hinge.
► Enlarge felling cut in direction of holding strap.
58
► Shout a warning.
► With arms outstretched, cut through the hold‐
ing strap from outside at a downward angle.
The tree falls.

13 After Finishing Work

13.1
► Switch off chainsaw, engage the chain brake
and remove the battery.
► If the chainsaw is wet: Allow the chainsaw to
dry.
► If the battery is moist or wet: Allow the battery
to dry,
► Clean the chainsaw.
► Clean the guide bar and saw chain.
► Loosen the wingnut.
► Turn the adjusting wheel 2 turns counterclock‐
wise.
The saw chain is now slack.
► Tighten the wing nut.
► Push the chain scabbard over the guide bar so
that it completely covers the guide bar.
► Clean the battery.
5 6

14 Transporting

4
14.1
► switch off chain saw, engage chain brake and
remove battery
► Fit the chain scabbard so that it completely
covers the guide bar.
Carrying the chainsaw
► Carry the chainsaw by holding the front handle
in your right hand with the guide bar pointing
to the rear.
Carrying the chainsaw in a vehicle
► Secure the saw to prevent turnover and move‐
ment.
14.2
► Switch off the chainsaw, engage the chain
brake and remove the battery.
► Check that the battery is in a safe condition.
► Pack the battery in packaging in such a way
that it cannot move inside the packaging.
► Secure the packaging so that it cannot move.
The battery is subject to the Carriage of Danger‐
ous Goods regulations. The battery is classified
as UN 3480 (lithium ion batteries) and has been
tested pursuant to UN Manual Tests and Criteria
Part III, Subsection 38.3.
The transport regulations can be found at
www.stihl.com/safety-data-sheets.
13 After Finishing Work
After Finishing Work
20.8.

Transporting the Chainsaw

Transporting the Battery

0458-022-9801-A