Heidolph MR Hei-Mix S Originalbetriebsanleitung Seite 33

Operation
WARNING
Risk of injury, risk of damage to property caused by splash-
ing fluids
When using open vessels, there is a risk that fluid will spray out at
high shaking frequencies.
➜
➜
➜
Automatic restart
When the mains is restored after a power interruption, the device
automatically starts up again with the set parameters!
Depending on the setting and structure, there is a risk that the
device will move uncontrolled and/or fluid will be sprayed out of the
vessels.
➜
➜ Always place individual vessels centrally on the stirrer plate.
➜
Use suitable attachments for simultaneous processing of several samples/vessels
(see section "Accessories" on page 35).
➜ Do not switch on the unit until all vessels including stirring bars are securely
positioned on the stirrer plate.
➜
Use the speed selector to set the required intensity.
Due to the phase angle control of the unit, the stirring bars in the
vessel do not move until the speed selector is at least in position 4.
Whenever possible, use closed vessels for processing corrosive,
toxic or biohazardous substances and seal them safely.
Increase the speed only gradually to the desired shaking
frequency, especially with open vessels, and observe the fluid
movements.
Always use the necessary and appropriate personal protective
equipment!
In the event of an interruption to the mains supply, switch off
the device via the main switch.
32