Activating The Heart Rate Monitor From The Power Saving Mode - Beurer PM 45 Gebrauchsanleitung

There are small retaining hooks on the
top and bottom edge (1) of the watch
case. The wrist band has the corre-
sponding slots (2).
Insert the watch case into the wrist
band. Guide the outer sides (3), which
enclose the side buttons, carefully over
the buttons.
Pay attention that the retaining hooks fit
exactly into the slots on the wrist band.
The casing must be directly attached to
the wrist band without any space. Oth-
erwise, the danger exists that the watch
could separate.
Please note: Only change the wrist band, if necessary. Excessive
swapping stresses the material.
Activating the heart rate monitor from the power saving
mode
You can activate your heart rate monitor by pressing any key. If the
heart rate monitor has not received any signal for approx. five
minutes, it switches to the power saving mode. At that point, only the
current time will be displayed. Press any key in order to reactivate
the watch.
Downloaded from www.Manualslib.com manuals search engine
9
G
B