Operation - Cameo MULTI FX BAR EZ Bedienungsanleitung

OPERATION

A few seconds after connecting to the mains, the effects spotlight is ready for operation and the previously selected operating mode is
activated. During the start-up process, the software version is displayed briefly (Vx.xx).
ACTIVATING DMX-CONTROL, CONFIGURING DMX START-ADDRESS (Addr)
Press the MODE button several times if necessary to access the highest menu level (Addr/chAn/ModE/SEt/inFo). Use the UP and DOWN
buttons to select the menu item Addr and confirm with ENTER. Using the UP and DOWN buttons, configure the desired DMX start address
and press ENTER to confirm (highest value dependent upon activated DMX mode).
-> ENTER UP/DOWN
SETTING DMX MODE (chAn)
Press the MODE button several times if necessary to access the highest menu level (Addr/chAn/ModE/SEt/inFo). Use the UP and DOWN
buttons to select the menu item chAn and confirm with ENTER. Use buttons UP and DOWN to select the desired DMX mode (5ch1, 5ch2,
07ch, 10ch 25ch, 28ch, 36ch) and confirm with ENTER. The currently configured DMX start address will then be displayed. If there is no
DMX control signal, the characters in the display will flash.If the display shut-off is activated, a small LED dot will flash in the display, The
blinking stops when a DMX control signal is present. Tables with the channel assignment of the different DMX modes can be found in these
instructions under DMX CONTROL.
-> ENTER-> UP/DOWN
ACTIVATING STAND-ALONE MODE (ModE)
Press the MODE button several times if necessary to access the highest menu level (Addr/chAn/ModE/SEt/inFo). Use the UP and DOWN
buttons to select the menu item ModE and confirm with ENTER. Use the control keys UP and DOWN to select the desired stand-alone mode
(StAt = static mode, Auto = automatic control, Soun = music control, SLAV = slave mode) and confirm with ENTER.
-> ENTER-> UP/DOWN
STAND-ALONE MODE STATIC MODE (StAt)
The operating mode STATIC mode offers the possibility to adjust the overall brightness of the LED spotlights and derby effects and to switch
on permanently or switch off one of the nine
colour macros of the 4 LED spotlights, one of the seven colour macros of the derby effects and the LED rotation speed and the strobe lights.
Activation of Static mode is as described previously in ACTIVATING STANDALONE MODE. After confirming with ENTER, select the functions
and effects one after the other with the ENTER button (see table static mode) and change values and status with the UP and DOWN keys,
and press ENTER to confirm.
Dimmer
-> ENTER->
UP/DOWN
StAt
Dimmer di00
LED spotlights PAr0
Derby effect dEr0
Derby rotation r 00
Strobe LEDs F on
-> ENTER
LED-Light Colour
-> ENTER-> -> ENTER->
UP/DOWN
– di99 Brightness of the LED spotlights and derby effects (value 00 = blackout, value 99 =
maximum)
– PAr9 Colour preset 0 to 9 (preset 0 = blackout)
– dEr7 Colour preset 0 to 7 (preset 0 = blackout)
– r 99 Rotation speed (value 00 = stop value 99 = fastest rotation)
– FoFF LEDs on or off permanently
-> ENTER
-> ENTER
Derby Colour Derby Rotation
-> ENTER->
UP/DOWN UP/DOWN
Strobe LEDs
-> ENTER-> -> ENTER
UP/DOWN
7