Wireless Footswitch; Installation - Cameo MULTI FX BAR EZ Bedienungsanleitung

WIRELESS FOOTSWITCH

Position the footswitch up to 10m from the lighting system and set the radio antennas of the foot switch and the lighting
system in a vertical position. Switch on the footswitch (on/off switch on the back) and activate the wireless connection
(foot = on) in the lighting system menu under device settings (SEt). If the foot switch is not being used, please disable the
wireless connection (foot = oFF). In DMX and Slave modes, the footswitch control is deactivated.
(Battery type for footswitch: 23AE, 4 rubber feet for sticking to the base included).
AUTO Auto programmes ALL Au01 to Au10. Programme selection by pressing AUTO.
MUSIC Music-controlled programmes ALL SP01 to SP10. Programme selection by repeated pressing of MUSIC. Adjust micro-
phone sensitivity level on the lighting system (rotary control MIC SENSITIVITY).
COLOUR Static colours for the LED spotlights and derby effects. Colour selection by repeatedly pressing COLOUR.
BLACKOUT The BLACKOUT button is used to switch off all spotlights and effects, regardless of operating mode enabled via the
footswitch. Press the BLACKOUT button again to reactivate the previously selected mode.

INSTALLATION

A
The multi-FX bar has 2 adjustable brackets for ceiling and traverse mounting. (A). The derby effects can be removed if necessary. To do this,
disconnect the device from the mains (remove mains plug) and disconnect the mechanical and electrical connection of the two derby effects.
Use one of the two specially created DMX modes (5-channel 2 or 28-channel) for controlling. Ensure firm installation and secure the device on
the safety lug (B).
The integrated 35mm stand flange (C) allows the multi-FX bar to be mounted on a suitable lighting stand. Top and centre of the multi-FX bar
is a knurled screw (D) to secure an additional light (do not install moving heads!). When attaching a spotlight, do not exceed the maximum
permissible load for the additional mounting option (5kg) and when connecting to the IEC power output jack, do not exceed the maximum
connection value (5A).
Important note: Overhead mounting requires extensive experience, including the calculation of the load limit values of the
installation material and regular safety inspection of all installation materials and spotlights. If you do not have these
qualifications, do not attempt to perform an installation yourself. Refer instead to a qualified professional.
B
D
C
A
11