Startup / Operation - BOMANN VS 7231.1 Bedienungsanleitung, Garantie

Reversing the door opening
If required, the door opening can be moved from the
right (supplied condition) to the left side.
WARNING:
When replacing the door stop, the appliance must be
disconnected from the power supply first.
NOTE:
 Ask another person to assist.
You possibly need:

driver as well as a thin-blade screwdriver.
 Loosen the screws (1) on the appliance back.
Remove the cover caps (2), loosen the screws
underneath and remove the appliance cover.
 Dismount the upper door hinge (3) and lift the
appliance door. Displace the door cover plug (4)
and set the appliance door safely aside.
 Tilt the appliance slightly backwards and block it
in this position. Unscrew the feet (5) and (6). Dis-
assemble the lower door hinge (7).
 Transfer and attach the lower door hinge (7) to
the opposite appliance side. Screw in the feet (6)
and (5) accordingly.
 Put the appliance back in the upright position.
Put on the appliance door and fix it its intended
position.
screw wrench, Phillips screw-
 Transfer and attach the upper door hinge (3) to
the opposite appliance side.
 Fasten the appliance cover and replace the cover
caps (2).
Check that the door is optimally aligned both vertical-
ly and horizontally to ensure a smooth opening and
closing of the door.

Startup / Operation

Prior to first use
CAUTION:
After transport, the appliance should be left standing
upright for four hours before connecting to the power
supply. Nonobservance could lead to malfunction of
the cooling system and causes an appliance break-
down.
Clean the appliance interior including all accessory
parts. Consider the instructions which we provide in
"Cleaning and Maintenance"
the chapter
Starting the appliance
 Connect the appliance to the power supply.
 Operate the temperature control. See also the
"Settings"
section
Settings
Setting [ 0 ] means that the appliance is in the off
state. Turn the temperature control clockwise, start-
ing from this setting; the appliance will turn on auto-
matically.
The power levels [ 1–7 ] regulate the different values
of the internal temperature.
Setting 0: Off state
Power level 1 + 2 :
lowest level → warmest internal temperature
Temperature range approx. +4°C∼+10°C
18
.
.