Startup / Operation - BOMANN VS 7339 Bedienungsanleitung, Garantie

 Transfer and attach the lower door hinge to the
opposite unit side; after you have unscrewed the
hinge pin and inserted it from the other side of the
hinge. Screw in the feet accordingly.
 Place the appliance back in the upright position.
Put on the unit door and fix it in the intended posi-
tion.
 Transfer and fasten the upper door hinge on the
opposite unit side.
 Put on the blind cap and hinge cover you remo-
ved at the beginning.
 Check the door rubber seal for an exact fit and, if
necessary, bring it into the correct position.
Check that the door is optimally aligned vertically and
horizontally so that the door can open and close
smoothly.

Startup / Operation

Prior to first use
CAUTION:
After transport, the appliance should be left standing
upright for four hours before connecting to the power
supply. Nonobservance could lead to malfunction of
the cooling system and causes an appliance break-
down.
Clean the appliance interior including all accessory
parts. Consider the instructions which we provide in
"Cleaning and Maintenance"
the chapter
Starting the appliance
 Connect the appliance to the power supply.
 Operate the temperature control. See also the
"Settings"
section .
Settings
Setting [ 0 ] means that the appliance is in the off
state. Turn the temperature control clockwise, start-
ing from this setting; the appliance will turn on auto-
matically.
The power levels [ 1 – 7 ] regulate the different val-
ues of the internal temperature.
Setting 0: Off state
Power level 1 + 2 :
lowest level → warmest internal temperature
Temperature range approx. +4°C∼+10°C
Power level 3 + 4 :
medium level → optimal operating temperature
Temperature range approx. +3°C∼+7°C
Power level 5 + 6 + 7* :
highest level → coldest internal temperature
Temperature range approx. 0°C∼+6°C
*Beware of high setting because the maximum level
may already means "freezing point".
Basically, the temperature changes depending on the
ambient temperature (place of installation), the fre-
quency of opening the door and the equipment.
During initial operation, adjust the lowest possible
temperature (= highest power level) first, until the
appliance has reached the desired operating tem-
perature. Afterwards it is recommended to turn the
control back to a medium setting; correcting the tem-
perature at a later point would then be easier.
NOTE:
In generally a medium power level works best for an
.
optimized food storage. A high power level also in-
creases the energy consumption.
Interior light
When opening the appliance door, the interior light
will turn on automatically.
20