Startup / Operation - BOMANN DTR 353.1 Bedienungsanleitung, Garantie

Leveling the appliance
Slight unevenness in the floor can be leveled out
using the front feet.
Check whether the appliance is leveled horizontally.
If the appliance is not in balance, the feet must be
adjusted.
Electrical connection
WARNING:
• The installation to the mains supply must conform
to the local standards and regulations.
• Improper connection may cause to an electric
shock!
• Do not modify the appliance plug. If the plug does
not fit properly to the outlet, let install a proper
outlet by an authorized specialist.
• The accessibility of the power plug must be en-
sured to disconnect the appliance from the power
supply in case of emergency.
• Make sure that the voltage supply matches the
specifications on the rating label before connect-
ing.
• Connect the mains cable to a properly installed
and earthed wall outlet.
• If the plug after installation is not accessible, a
corresponding disconnect device must be availa-
ble to meet the relevant safety regulations.

Startup / Operation

Prior to first use
CAUTION:
After transport, the appliance should be left standing
upright for four hours before connecting to the power
supply. Nonobservance could lead to malfunction of
the cooling system and causes an appliance break-
down.
Clean the appliance interior including all accessory
parts. Consider the instructions which we provide in
"Cleaning and maintenance".
the chapter
Starting the appliance
• Connect the appliance to the power supply.
• Set the operating conditions. See also the follow-
ing sections.
Settings
Position [ 0 ] means that the appliance is in the
switched-off state. Turn the temperature control
clockwise from this position, the appliance switches
on automatically.
The power levels control the different values of the
internal temperature.
Power level
lowest level, warmest internal tempera-
1, 2
approx. +4°C ∼ +10°C
ture →
medium level, optimal operating tem-
3
perature →
highest level, coldest internal tempera-
4, 5*
approx. 0°C ∼ +6°C
ture →
*Beware of high setting because the maximum level may
already mean "freezing point".
The freezer temperature is automatically con-

trolled by the power level setting in the fridge.
Basically, the temperature changes depending on the
ambient temperature (place of installation), the fre-
quency of opening the door and the equipment.
For initial operation, first set the lowest possible in-
ternal temperature (= highest power level) until the
appliance has reached the desired operating tem-
perature. It is recommended to reset to a medium
power level afterwards, then you can easily make
any temperature correction.
Recommendation, for optimized food storage and to
avoid food waste, a medium power level is generally
22
approx. +3°C ∼ +7°C