Startup / Operation - BOMANN VS 7339 Bedienungsanleitung, Garantie

• Remove the hinge cover as well as the opposite
blind cap and dismount the upper door hinge.
• Lift out the appliance door; remove the door stop-
per on the door underside and attach the deliv-
ered door stopper to the corresponding other door
underside.
• Move the blind plug on the door topside and set
the door safely aside.
• Tilt the appliance slightly backwards and block it
in this position. Unscrew the feet and dismount
the lower door hinge.
• Transfer and attach the lower door hinge to the
opposite unit side; after you have unscrewed the
hinge pin and inserted it from the other side of the
hinge. Screw in the feet accordingly.
• Place the appliance back in the upright position.
Put on the unit door and fix it in the intended posi-
tion.
• Transfer and fasten the upper door hinge on the
opposite unit side.
• Put on the blind cap and hinge cover you re-
moved at the beginning.
• Check the door rubber seal for an exact fit and, if
necessary, bring it into the correct position.
Check that the door is optimally aligned vertically and
horizontally so that the door can open and close
smoothly.

Startup / Operation

Prior to first use
CAUTION:
After transport, the appliance should be left standing
upright for four hours before connecting to the power
supply. Nonobservance could lead to malfunction of
the cooling system and causes an appliance break-
down.
Clean the appliance interior including all accessory
parts. Consider the instructions which we provide in
"Cleaning and Maintenance"
the chapter
Starting the appliance
• Connect the appliance to the power supply.
• Set the operating conditions. See also the follow-
ing sections.
Settings
Position [ 0 ] means that the appliance is in the
switched-off state. Turn the temperature control
clockwise from this position, the appliance switches
on automatically.
The power levels control the different values of the
internal temperature.
Power level
lowest level, warmest internal tempera-
1, 2
ture →
medium level, optimal operating tem-
3, 4
perature →
highest level, coldest internal tempera-
5, 6, 7*
ture →
*Beware of high setting because the maximum level may
already mean "freezing point".
Basically, the temperature changes depending on the
ambient temperature (place of installation), the fre-
quency of opening the door and the equipment.
For initial operation, first set the lowest possible inter-
nal temperature (= highest power level) until the ap-
pliance has reached the desired operating tempera-
ture. It is recommended to reset to a medium power
level afterwards, then you can easily make any tem-
perature correction.
Recommendation, for optimized food storage and to
avoid food waste, a medium power level is generally
best. A high power level also increases energy con-
sumption.
22
.
approx. +4°C ∼ +10°C
approx. +3°C ∼ +7°C
approx. 0°C ∼ +6°C