Startup / Operation - BOMANN VS 7350 Bedienungsanleitung, Garantie

• Make sure that the voltage supply matches the
specifications on the rating label before connect-
ing.
• Connect the mains cable to a properly installed
and earthed wall outlet.
• If the plug after installation is not accessible, a
corresponding disconnect device must be availa-
ble to meet the relevant safety regulations.
Reversing the door opening
If required, the door opening can be moved from the
right (supplied condition) to the left side.
WARNING:
When replacing the door stop, the appliance must be
disconnected from the power supply first.
NOTE:
• Ask another person to assist.
You possibly need:
•
driver as well as a thin-blade screwdriver.
• Loosen the screws (1) on the appliance back.
Remove the cover caps (2), loosen the screws
underneath and remove the appliance cover.
• Disassemble the upper door hinge (3) and lift out
the appliance door. Move the dummy plug (4) and
set the appliance door safely aside.
screw wrench, Phillips screw-
• Tilt the appliance back slightly and secure it in this
position. Unscrew the feet (5) and (6). Disassem-
ble the lower door hinge (7).
• Transfer and fasten the lower door hinge (7) to
the opposite appliance side. Screw in the feet (6)
and (5) accordingly.
• Place the appliance back in the upright position.
Put on the appliance door and fix it in the intend-
ed position.
• Transfer and fasten the upper door hinge (3) to
the opposite appliance side.
• Fasten the appliance cover and replace the cover
caps (2).
Check whether the door is optimally aligned vertically
as well as horizontally, so that a smooth opening and
closing of the door is ensured.

Startup / Operation

Prior to first use
CAUTION:
After transport, the appliance should be left standing
upright for four hours before connecting to the power
supply. Nonobservance could lead to malfunction of
the cooling system and causes an appliance break-
down.
Clean the appliance interior including all accessory
parts. Consider the instructions which we provide in
"Cleaning and maintenance"
the chapter
Starting the appliance
• Connect the appliance to the power supply.
• Set the operating conditions. See also the follow-
ing sections.
20
.