Startup / Operation - BOMANN KB 7346 Bedienungsanleitung, Garantie

• Connect the mains cable to a properly installed
and earthed wall outlet.
• If the plug after installation is not accessible, a
corresponding disconnect device must be availa-
ble to meet the relevant safety regulations.
Reversing the door opening
If required, the door opening can be moved from the
right (supplied condition) to the left side.
WARNING:
When replacing the door stop, the appliance must be
disconnected from the power supply first.
NOTE:
You possibly need:
screw wrench, Phillips screwdriv-
er as well as a thin-blade screwdriver.
• Remove the blind cap (1) and the hinge cover (2).
• Loosen the screws (3), remove the door hinge (4)
and lift the appliance door.
• Move the blind plug (5) of the appliance door to
the opposite side. Set the door aside safely.
• Tilt the appliance slightly backwards and block it
in this position. Dismount the door hinge (6) with
its base by loosening the screws (7). Unscrew the
separate foot (8).
• Move and fasten the door hinge (6) incl. base with
the screws (7). Screw in the separate foot (8) ac-
cordingly.
• Put the appliance back in the upright position. Put
on the appliance door and fix it in the intended
position. Move and fasten the door hinge (4) with
the screws (3).
• Replace the hinge cover (2) and move the blind
cap (1) into the exposed hole.
Check that the door is optimally aligned both vertical-
ly and horizontally to ensure a smooth opening and
closing of the door.

Startup / Operation

Intended use
The appliance is intended for private/household use.
It is suitable for cooling perishable foods such as
milk, dairy products, meat, fish, eggs, margarine,
various spreads and fruit and vegetables that are not
sensitive to cold.
This cooling box is not suitable for freezing food!
Prior to first use
CAUTION:
After transport, the appliance should be left standing
upright for four hours before connecting to the power
supply. Nonobservance could lead to malfunction of
the cooling system and causes an appliance break-
down.
Clean the appliance interior including all accessory
parts. Consider the instructions which we provide in
"Cleaning and maintenance"
the chapter
Starting the appliance
• Connect the appliance to the power supply.
• Set the operating conditions. See also the follow-
ing sections.
Settings
Position [ OFF ] means that the appliance is in the
switched-off state. Turn the temperature control
19
.