Troubleshooting; Technical Data - BOMANN VS 7231.1 Bedienungsanleitung, Garantie

Cleaning the appliance including interior
 Clean the appliance interior, the exterior surfaces,
the accessories and the door seal regularly with
warm water and mild detergent; or with a clean,
damp microfiber cloth without cleaning agent.
 Remove the appliance content and storage it at a
cool location.
 Clean the thaw water discharge channel / opening
carefully e.g. with a pipe cleaner.
 After everything was thoroughly dried, you can
restart the operation.
Depending on model:

the dust that has accumulated on the appliance
back and condenser (metal grille). To do this, use
a soft brush or a vacuum cleaner.
Defrosting
CAUTION:
Never use metal objects (e.g. knifes) to remove ice
from the evaporator. Otherwise it can be damaged.
The appliance has a semi automatic defrosting sys-
tem. During defrosting water drops drains off at the
back of the cooling chamber. The thaw water running
through a channel, is collected in a drip tray located
on the compressor, where it will evaporate. Make
sure the water discharge opening does not get
clogged. A light formation of ice on the interior back
during operation is normal.
A permanently high power level can lead to increa-
sed ice formation. In this case, the fridge compart-
ment can be defrosted manually
level.
Changing the light
CAUTION:
Do NOT remove the cover of the light. The LED light
may be replaced / repaired in case of failure / defect
only by an authorized specialist.
Wipe at least once a year
→ set a lower power

Troubleshooting

Before you contact an authorized specialist
Problem Cause / Action
Unit is not
∙ Check the power supply / tem-
working
perature setting / ambient temper-
properly or
ature. ∙ Unblock the ventilation
at all
openings, install the unit freely.
Loading is
∙ Check the temperature setting /
too warm
ambient temperature. ∙ Open the
door only as long as necessary.
Loud noise
∙ Check the appliance position.
during opera-
∙ See the section
tion noise".
Water on the
∙ Check the temperature setting /
unit bottom
water discharge channel or open-
ing.
Light does
∙ Check the power supply.
not work
∙ See
NOTE:
If a problem persists after following the steps above,
contact your trader or an authorized technician.

Technical Data

Climate class N/ST: this appliance is intended to be
used at ambient temperature ranging from 16°C to
38°C.
Electrical connection............................................
Power voltage: .........................220-240 V~ / 50 Hz
Rated power: ...............................................60 W
Rated current: ..............................................2.0 A
Dimension H x W x D / Weight...............................
Appliance size: ......................83.1 x 45.0 x 49.0 cm
Net weight: ..................................approx. 22.0 kg
For more information about the product, scan the QR
code on the supplied energy label and/or visit the
21
"Operating
"Changing the light".