Cleaning; Troubleshooting - CASO DESIGN VC11 Original Bedienungsanleitung

Attention
► The sealing bar is hot after it is used. There is a danger of burns! Wait until the device
has cooled down.
► Clean the device after use as soon as it has cooled down. Extended waiting
unnecessarily complicates cleaning and can make it impossible in extreme cases.
Excessive accumulations of dirt can even damage the device under certain
circumstances.
► Never immerse the device in water or other liquids and do not place in the dishwasher.
► If dampness penetrates into the device, this can damage the electronic components.
Please ensure that no liquid can enter the interior of the device.
► Do not use any aggressive or abrasive cleaning agents or solvents.
► Do not scrape off stubborn dirt with hard items.
► Dry thoroughly before using again.
17.2

Cleaning

◆
Outside of the unit
Wipe the outside of the unit with a damp cloth or sponge and mild dish soap.
◆
Inside of the device
To clean the inside of the unit wipe away any food or liquids with a paper towel.
◆
Preservation bags
Washing the bagging material in warm water with a mild dishwashing soap, then rinse the
bags well and allow drying thoroughly before reusing
Attention
► Bags used to store raw meats, fish or greasy foods can't be reused.
◆
Sealing profile (which presses the bag against the sealing bar)
Remove the sealing profile and clean it in warm soapy water.
► The sealing profile should be cleaned thoroughly before installing it again.
► Be careful during re-installation, so that nothing will be damaged and sealing profile is
placed well so that the device can work properly.

18 Troubleshooting

This chapter provides you with important notices with regard to operating the device.
Observe the following notices to avoid dangers and damages:
Please note
.
42