Assembly; Carton Contents - Briggs & Stratton 020224 Bedienungsanleitung

Briggs & Stratton Generac Generator Discount Parts Call 606-678-9623 or 606-561-4983

ASSEMBLY

IMPORTANT: Read entire operator's manual before you
attempt to assemble or operate your new pressure washer.
Remove Pressure Washer From
Carton
• Remove the parts bag, accessories, and inserts included
with pressure washer.
• Slice two corners at the end of carton from top to
bottom so the panel can be folded down flat.
• Roll pressure washer out of carton.

Carton Contents

Items in the carton include:
• Main Unit
• Safety Goggles
• Handle
• Plastic Accessory Tray
• High Pressure Hose
• Spray Gun
• Nozzle Extension with Quick Connect Fitting
• Parts Bag (which includes the following):
• Operator's Manual
• Engine Manual
• Maintenance Kit
• Hose Fittings
• Quick Connects
• Bag containing 4 multi–colored Quick Connect Spray
Tips
• Handle Fastening Hardware Kit (which includes):
• Carriage Bolt
• "L" Bolt
• Plastic Knobs (2)
• "J" Hook
• Chemical Hose Clip
• Self Tapping Screws (4)
If parts are missing or damaged, contact the local Briggs &
Stratton service center.
BSPP 2700 PSI Pressure Washer
www.mymowerparts.com
PREPARING PRESSURE
WASHER FOR USE
To prepare your pressure washer for operation, you
will need to perform these tasks:
1. Attach accessory tray to handle, then attach handle to
main unit.
2. Add oil to engine crankcase.
3. Add fuel to fuel tank.
4. Connect high pressure hose to spray gun and pump.
5. Connect water supply to pump.
6. Attach nozzle extension to spray gun.
7. Select/attach quick connect spray tip to nozzle
extension.
Attach Handle and Accessory Tray
NOTE: All assembly operations given in this section will
be described from the perspective of assembling the
pressure washer from the rear.
1. Slide plastic accessory tray onto handle and align holes
in accessory tray with holes on handle (Figure 2).
Figure 2 — Attach Accessory Tray
2. Secure tray to handle with self tapping screws using a
#2 phillips screwdriver. Ensure screws are tight but not
crushing the plastic accessory tray.
6