Briggs & Stratton 020224 Bedienungsanleitung Seite 7

Briggs & Stratton Generac Generator Discount Parts Call 606-678-9623 or 606-561-4983
3. Place handle assembly onto handle supports connected
to main unit. Make sure holes in handle align with holes
on handle supports (Figure 3).
Figure 3 — Attach Handle to Base
Align Holes
NOTE: It may be necessary to move the handle supports
from side to side in order to align the handle so it will slide
over the handle supports.
4. Insert "L" bolt through hole on right side of handle
(viewing from handle side of unit) and attach plastic
knob.Tighten knob by hand (Figure 4).
Figure 4 — Secure Handle
5. Insert carriage bolt through left side hole from outside
of unit and attach a plastic knob from inside of unit
(viewing unit from the handle side).Tighten by hand
(Figure 4).
6. Insert "J" hook into second from left slot in accessory
tray (Figure 5).
Figure 5 — Install "J" Hook on Accessory Tray
BSPP 2700 PSI Pressure Washer
Handle
Handle
Supports
www.mymowerparts.com
7. Pinch chemical hose and slide it into metal clip as
shown in Figure 6.
Figure 6 — Slide Chemical Hose into Metal Clip
8. Tilt unit up by handle and attach metal clip to rib on
center underside of accessory tray (Figure 7). Slide
chemical hose through metal clip so that it is tight but
not kinked.
Figure 7 — Slide Metal Clip onto Accessory Tray Flange
Add Engine Oil and Fuel
• Place pressure washer on a level surface.
CAUTION
Any attempt to crank or start the engine before it has
been properly filled with the recommended oil will result
in equipment failure.
• Refer to engine manual for oil and fuel fill information.
• Damage to equipment resulting from failure to follow this
instruction will void warranty.
• Refer to engine operator's manual and follow oil and fuel
recommendations and instructions.
NOTE: Check oil often during engine break–in. Refer to
engine operator's manual for recommendations.
7