Briggs & Stratton 020224 Bedienungsanleitung Seite 8

Briggs & Stratton Generac Generator Discount Parts Call 606-678-9623 or 606-561-4983
Connect Hose and Water Supply to
Pump
IMPORTANT: To avoid pump damage, you must assemble
the nozzle extension to the spray gun and attach all hoses
before you start the engine.
1. Attach one end of high pressure hose to high pressure
outlet on pump (Figure 8).Tighten by hand.
Figure 8 — Connect High Pressure Hose to Pump
2. Attach other end of hose to base of spray gun
(Figure 9).Tighten by hand.
Figure 9 — Connect High Pressure Hose to Spray Gun
3. Before connecting garden hose to water inlet, inspect
inlet screen (Figure 10). Clean screen if it contains debris
or replace if damaged. DO NOT RUN PRESSURE
WASHER IF SCREEN IS DAMAGED.
Figure 10 — Connect Garden Hose to Water Inlet
4. Run water through garden hose for 30 seconds to clean
out any debris.
IMPORTANT: DO NOT siphon standing water for water
supply. Use ONLY cold water (less than 100°F).
5. Attach female quick connect to garden hose.Attach male
quick connect to water inlet on pump (Figure 11).
BSPP 2700 PSI Pressure Washer
Connect high
pressure hose
here
Inspect inlet
screen, DO
NOT use if
damaged, clean
if dirty.
www.mymowerparts.com
Figure 11 — Connect the Garden Hose to Water Inlet
6. Connect garden hose (not to exceed 50 feet in length)
to water inlet (Figure 11). Pull back on collar of quick
connect, slide fitting onto pump and let go of collar. Pull
on hose to be sure of a tight connection.
CAUTION
There MUST be at least ten feet of unrestricted garden
hose between the pressure washer inlet and any flow
shut off device, such as a 'Y' shut-off connector or other
convenience-type water shut-off valve.
• Damage to equipment resulting from failure to follow this
instruction will void warranty.
7. Turn ON water and squeeze trigger on spray gun to
purge pump system of air and impurities.
WARNING
High pressure spray can cause paint chips or
other particles to become airborne.
• Always wear eye protection when using this equipment or in
vicinity of where equipment is in use.
• Before starting the pressure washer, be sure you are wearing
adequate eye protection.
Checklist Before Starting Engine
Review the unit's assembly to confirm you have performed
all of the following:
1. Make sure handle is in place and secure.
2. Check that oil has been added to the proper level in
engine crankcase.
3. Add proper fuel to fuel tank.
4. Check for properly attached hose connections.
5. Check to make sure that there are no kinks, cuts, or
damage to high pressure hose.
6. Provide a proper water supply at an adequate flow.
7. Be sure to read "Safety Rules" and "How To Use Your
Pressure Washer" before using pressure washer.
8