Briggs & Stratton 020224 Bedienungsanleitung Seite 10

Briggs & Stratton Generac Generator Discount Parts Call 606-678-9623 or 606-561-4983
8. Engage safety latch to spray gun trigger (Figure 15).
Figure 15 — Spray Gun with Safety Latch Engaged
9. Move variable pressure control lever to "High"
position, shown on engine as a rabbit (Figure 16).
Figure 16 - Variable Pressure Control Lever
10. Start engine according to instructions given in engine
operator's manual.
Rapid retraction of starter cord (kickback) will
pull hand and arm toward engine faster than
you can let go.
Broken bones, fractures, bruises or sprains could
result.
• When starting engine, pull cord slowly until resistance is felt
and then pull rapidly to avoid kickback.
• If engine starts and fails to continue to run or if increased
resistance is felt during starting pull attempts, squeeze trigger
on spray gun.
Safety Latch
WARNING
www.mymowerparts.com
BSPP 2700 PSI Pressure Washer
Running engines produce heat.Temperature of
muffler and nearby areas can reach or exceed
150°F (65°C).
Severe burns can occur on contact.
Combustible debris, such as leaves, grass, brush,
etc. can catch fire.
• DO NOT touch hot surfaces.
• Allow equipment to cool before touching.
• The pressure washer must be at least 5 feet from structures
having combustible walls and/or other combustible materials.
• Keep at least 3 feet of clearance on all sides of pressure
washer for adequate cooling, maintenance and servicing.
How To Stop Pressure Washer
• Move variable pressure control lever to "Stop" position.
• Turn engine off according to instructions given in the
engine operator's manual.
• Squeeze trigger on the spray gun to relieve
pressure in the hose.
The high pressure stream of water that this
equipment produces can pierce skin and its
underlying tissues, leading to serious injury and
possible amputation.
Spray gun retains high pressure when pressure
washer is shut down, which can cause injury.
• Keep high pressure hose connected to pump and spray gun
while system is pressurized.
• Squeeze trigger on spray gun to relieve trapped pressure,
every time you stop engine. Engage trigger lock on spray gun.
NOTE: A small amount of water will squirt out when
pressure is released.
How to Use Accessory Tray
The unit is equipped with an accessory tray with places to
store your nozzle extension , and slots to hold the cleaning
solution bottle and the detergent siphoning filter.There are
also two hooks at the ends of the handle to hold your
spray gun and high pressure hose.
NOTE: The extra holes in the tray are for storing a brush
and a turbo wand.The brush and turbo wand are NOT
included with your pressure washer.You can buy these
items as optional accessories.
10
WARNING
WARNING