Panasonic EY7430 Bedienungsanleitung Seite 9

hands away from the drill bit and any
shavings.
24) Do not wear gloves when operating the
tool, as they may get caught by the drill,
leading to injury.
25) Battery terminals, screw shavings, and
tool accessories such as drill bits will be
very hot immediately after operation. Do
not touch them as there is a risk of burning
yourself.
Symbol
V
Direct current
n
No load speed
o
Revolutions or reciprocations
... min
-1
per minutes
Electrical capacity of battery
Ah
Forward rotation
Reverse rotation
Rotation only
To reduce the risk of
injury, user must read and
understand instruction
For indoor use only.
EY7530_7430_3732_0L32_02(Eng).indd
Meaning
Volts
pack
manual.
- 9 -
9
Model No: EY7430 & EY7530
II. ASSEMBLY
Attaching or Removing Bit for
NOTE:
When attaching or removing a bit,
disconnect battery pack from tool or
place Forward/Reverse lever in the
center position (switch lock).
This tool is equipped with a keyless drill
chuck.
1. Attachment【Fig.1】
Insert the bit and turn the lock collar
clockwise (looking from the front) to
tighten firmly until it stops clicking.
2. Removal【Fig.2】
Turn the lock collar counterclockwise
(looking from the front), then remove
the bit.
NOTE:
• If excessive play occurs in the chuck,
secure the drill in place and ①
open the chuck jaws by turning the
lock collar and ② tighten the screw
(left-handed screw) with a screwdriver
by turning it counterclockwise (looking
from the front).
【Fig.3】
• To ensure that the bit is held in place
securely, fasten the keyless chuck
tightly.
• Always keep drill bits sharp and in
good condition. Working with dull or
damaged drill bits can lead to injury
Attaching or Removing Bit for
NOTE:
When attaching or removing a bit,
disconnect battery pack from tool or
place Forward/Reverse lever in the
center position (switch lock).
1. Hold the collar of quick connect chuck
and pull it out from the driver.
2. Insert the bit into the chuck. Release the
collar.
3. The collar will return to its original
position when it is released.
4. Pull the bit to make sure it does not
come out.
5. To remove the bit, pull out the collar in
the same way.
EN
EY7430
EY7530
2014/08/18 15:40:50