Ey7430 Ey7530 - Panasonic EY7430 Bedienungsanleitung

Switch and Forward/Reverse Lever
Operation
EY7430
【 Fig.4 】 for
【 Fig.7 】 for EY7530
CAUTION:
To prevent damage, do not operate
Forward/Reverse lever until the bit
comes to a complete stop.
Forward Rotation Switch Operation
1. Push the lever for forward rotation.
2. Depress the trigger switch slightly to
start the tool slowly.
3. The speed increases with the amount
of depression of the trigger for efficient
tightening of screws and drilling .
The brake operates and the chuck
stops immediately when the trigger is
released.
4. After use, set the lever to its center
position (switch lock).
Reverse Rotation Switch Operation
1. Push the lever for reverse rotation.
Check the direction of rotation before
use.
2. Depress the trigger switch slightly to
start the tool slowly.
3. After use, set the lever to its center
position (switch lock).
NOTE:
The drill will stop if the Forward/Reverse
lever is pushed while the trigger is
held down.This will happen even if
the Forward/Reverse lever is pushed
accidentally.
You will not be able to hold the trigger
down again until you release it and
return the Forward/Reverse lever to its
original position.
Clutch Torque Setting for
Adjust the torque to one of the 17 clutch
settings or "
【 Fig.5 】
CAUTION:
Test the setting before actual
operation.
EY7530_7430_3732_0L32_02(Eng).indd
EY7430
" position.
- 11 -
11
NOTE for EY7430
• The clutch delivers different levels
of torque based on the location,
material, and type of the screw. Be
sure to check these before starting.
• Due to the way the product is
constructed, you may sometimes not
be able to set it to drill mode after
operating the clutch. This does not
mean the product is broken. When
this happens, set the clutch to (1) and
rotate a few times.
• When loosening the screws, adjust
the torque position to "
Model No: EY7430 & EY7530
Speed Selection for EY7430
Choose 1 (LOW) or 2 (HIGH) speed to
suit the use.
【 Fig.6 】
The more the variable speed control
trigger is pulled, the higher the speed
becomes.
CAUTION:
• Check the speed selector switch
before use.
• Use at low speed when high torque
is needed during operation. (Using
at high speed when high torque
is required may cause a motor
breakdown.)
• Do not operate the speed selector
switch [1 (LOW)- 2 (HIGH)] while
pulling on the speed control
trigger. This can cause the
rechargeable battery to wear
quickly or damage the internal
mechanism of the motor.
* See specifications for " MAXIMUM
RECOMMENDED CAPACITIES ".
• Continued operation with the
speed control trigger held down
can cause electric parts to break
and the tool to stop working.
NOTE:
• Always use the low speed [1 (LOW)]
when drilling large holes with a wood
drill bit or a hole saw.
EN
".
2014/08/18 15:40:52