Cleaning The Device - HEYLO DE 20 SH-U Betriebsanleitung

Electric heater DE 20 SH-U
Attention
NOTICE
20.1

Cleaning the device

NOTICE
The cleaning intervals for the device will depend on the conditions of use. Therefore check and clean the device
regularly.
Cleaning can be performed with compressed air, a vacuum cleaner (e.g. for cleaning dusty components) or by
wiping with a damp cloth. CAUTION! Never use a hose or high pressure cleaner.
CAUTION! Electrical components must never come into contact with water or chemical cleaners.
The electrical system must be checked regularly for signs of damage.
Proceed as follows to clean and check the condition of the device:
a) Switch off the device at the device switch and pull out the mains plug.
b) Wait until the temperature at the outlet nozzle has dropped to ≤ 40°C
Cleaning the device
NOTICE
74 / 83
Damage to property through insufficient maintenance
Insufficient maintenance leads to higher wear and expensive repairs.
a) Carry out the necessary maintenance work in accordance with the manufactur-
er's instructions.
b) Observe the manufacturer's instructions on looking after the mechanical compo-
nents.
c) In the event of damage to the mechanical equipment, take the device out of op-
eration immediately and arrange for professional repair using original spare
parts.
Performing regular maintenance
Regular maintenance constitutes one element of the intended use of the device and it
is an absolute prerequisite for safe and efficient operation.
Suitable cleaning agents
You can obtain suitable cleaning agents for cleaning your device from your dealer or
directly from HEYLO.
HEYLO special cleaner
Metal components can be cleaned with the special cleaner, Article No. 18800105.
Plastic components can be cleaned with the special cleaner, Article No. 18800104.
EN