Checking And Cleaning The Device - HEYLO KS 35 T Betriebsanleitung

18.1

Checking and cleaning the device

The cleaning intervals for the device depend on the
actual operating conditions. Check and clean the
device regularly.
NOTICE
Suitable cleaning products
Suitable cleaning products for your device are
available from your dealer or directly from HEYLO.
– Cleaning can be performed with compressed air,
a vacuum cleaner or by wiping with a damp
cloth. CAUTION! Never use a hose or high
pressure cleaner.
– The electrical system must be checked regularly
for signs of damage.
– To ensure trouble-free operation, regularly check
and clean the filters of the device.
Switching device off
To clean and check the device, switch it off as fol-
lows:
a) Switch off the device at the device switch and
let the cooling time elapse (fan stops).
b) Disconnect the power plug.
Cleaning device housing
a) Clean the housing with a damp, lint-free cloth
and a mild detergent. The original gloss can be
restored with polish.
Clean heat exchanger
Fig. 41: Clean heat exchanger
1 Exhaust gas pipe
3 Housing cover
screws (both sides)
a) Disconnect the exhaust gas pipe from the ex-
haust gas outlet.
b) Loosen the screw connection of the housing
cover and remove the cover.
c) Clean the heat exchanger with a pipe brush and
remove the loose soot and dirt with a suitable
vacuum cleaner.
EN
1
2
3
2 Front housing cover
d) Remount the housing cover and the exhaust
gas pipe.
Cleaning fuel tank
Clean the fuel tank at least once a year, or as re-
quired.
Fig. 42: Emptying fuel tank
1 Fuel tank
a) Place a container that can hold the entire tank
volume under the fuel tank cap.
b) Open the fuel tank cap.
c) Rinse the tank with clean fuel.
d) Dispose of fuel according to the relevant statu-
tory regulations.
Cleaning filter
Clean the filter at least once a year, or as required.
Always replaced damaged filters.
Cleaning tank inlet filter
Fig. 43: Cleaning inlet filter
1 Screw cap of fuel
tank
a) Open the fuel tank cap.
b) Pull the inlet filter from the tank.
c) Clean the inlet filter with clean fuel. Do not
damage the filter.
d) Mount the inlet filter in the tank.
e) Mount the screw cap.
Oil heater KS 35 T
1
2
2 Fuel tank cap
1
2
2 Inlet filter
39 / 44