Adjusting The Anti-Scalp Rollers - Toro Z Master Professional 7000-Serie Bedienungsanleitung

Adjusting the Anti-Scalp
Rollers
Machines with Side Discharge
Whenever you change the height-of-cut, adjust the
height of the anti-scalp rollers.
1. Park the machine on a level surface, disengage
the blade-control switch, and engage the parking
brake.
2. Shut off the engine, remove the key, and wait
for all moving parts to stop before leaving the
operating position.
3. Adjust the anti-scalp rollers as shown in
29, Figure 30, and
Figure 29
1. Anti-scalp roller
2. Spacer
3. Bushing
Figure 30
1. Anti-scalp roller
2. Bushing
Figure
Figure 31.
4. Flange nut
5. Bolt
3. Flange nut
4. Bolt
1. Anti-scalp roller
2. Spacer
3. Bushing
Machines with Rear Discharge
Whenever you change the height of cut, it is
recommended to adjust the height of the anti-scalp
rollers.
1. Park the machine on a level surface, disengage
the blade-control switch, and engage the parking
brake.
2. Shut off the engine, remove the key, and wait
g029955 for all moving parts to stop before leaving the
operating position.
3. Adjust the anti-scalp rollers as shown in
32 and Figure
g029956
1. Flange nut
2. Anti-scalp roller
30
Figure 31
4. Flange nut
5. Bolt
33.
Figure 32
3. Bushing
4. Bolt
g029957
Figure
g024242