Adding Light Oil Or Spray Lubrication; Greasing The Mower Deck And Belt Idlers - Toro Z Master Professional 7000-Serie Bedienungsanleitung

Figure 48
Rear Discharge Machines
Adding Light Oil or Spray
Lubrication
Service Interval: Every 100 hours
Side-Discharge Machines
Use light oil or spray lubricant to lubricate the deck-lift
pivots.
Figure 49
Rear-Discharge Machines
Service Interval: Every 150 hours
Use light oil or spray lubricant to lubricate the machine
in the following areas:
•
Seat-switch actuator
•
Brake-handle pivot
•
Brake-rod bushings
•
Motion-control bronze bushings
Greasing the Mower Deck
and Belt Idlers
Service Interval: Every 25 hours—Grease the mower
Grease Type: No. 2 lithium or molybdenum grease
decal140-4363
Important:
spindles are full of grease weekly.
1. Park the machine on a level surface, disengage
the blade-control switch, and engage the parking
brake.
2. Shut off the engine, remove the key, and wait
for all moving parts to stop before leaving the
operating position.
3. Loosen the bottom bolt holding the mower-deck
curtain to the mower deck; refer to
the Mower-Deck Curtain (page
4. Remove the sheet-metal guard; refer to
Removing the Sheet-Metal Guard (page 41)
5. Remove the belt covers.
6. Grease the idler arm on the mower deck
50).
7. Grease the fittings on the push arms
or Figure
g017028
42
deck and spindles.
Make sure that the mower-deck
51).
Releasing
41).
(Figure
(Figure 50