For Machines With An Electric Deck Lift; Adjusting The Anti-Scalp Rollers - Toro Z Master 4000 Serie Bedienungsanleitung

Adjusting the Height of Cut
For Machines with an Electric
Deck Lift
1. Push up on the deck-lift switch
Figure 30
1. Push up to raise the deck.
2. Select a hole in the height-of-cut bracket
corresponding to the height of cut desired, and
insert the pin (Figure
Figure 31
1. Height-of-cut pin
3. Push down on the deck-lift switch to set the
height of cut (Figure
(Figure 30).
2. Push down to lower the
deck.
31).
2. Height-of-cut bracket
30).
Adjusting the Anti-Scalp
Rollers
Whenever you change the height of cut, adjust the
height of the anti-scalp rollers.
Note:
Adjust the anti-scalp rollers so that the rollers
do not touch the ground in normal, flat mowing areas.
1. Park the machine on a level surface, disengage
the blade-control switch and engage the parking
brake.
2. Shut off the engine, remove the key, and wait
for all moving parts to stop before leaving the
operating position.
3. Adjust the anti-scalp rollers as shown in
32.
g332765
1. Anti-scalp roller
2. Spacer
3. Bushing
g332766
28
Figure 32
4. Flange nut
5. Bolt
Figure
g038079