Changing The Hydraulic Fluid And Filter - Toro Z Master Professional 7000-Serie Bedienungsanleitung

6. Run the machine at low idle for 15 minutes to
allow any air to purge out of the system and
warm the fluid; refer to
Normal Weather (page
Note:
Check the fluid level while the fluid is
warm. The fluid should be between cold and hot.
7. If required, add fluid to the hydraulic tank.
Note:
The fluid level should be to the top of
the hot level of the baffle, when the fluid is hot
(Figure 94).
8. Install the cap on the filler neck.
1. Hot fluid level—full
Changing the Hydraulic
Fluid and Filter
Service Interval: After the first 25 hours
Every 250 hours—Change the hydraulic filter
and hydraulic fluid when using Mobil
Every 500 hours—Change the hydraulic
filter and hydraulic fluid when using Toro
HYPR-OIL ™ 500 hydraulic fluid.
Use summer filter above 0°C (32°F)
Use winter filter below 0°C (32°F)
1. Park the machine on a level surface, disengage
the blade-control switch, and engage the parking
brake.
2. Shut off the engine, remove the key, and wait
for all moving parts to stop before leaving the
operating position.
Important:
Do not substitute automotive
oil filter or severe hydraulic system damage
may result.
3. Place drain pan under filter, remove the old filter
and wipe the filter adapter gasket surface clean
(Figure 95).
Starting the Engine in
26).
Figure 94
2. Cold fluid level—full
®
1. Hydraulic filter
4. Remove the right hydraulic line that comes into
the adapter
5. Allow the fluid to drain out of the system into the
drain pan.
6. Install the right hydraulic line to the adapter
(Figure
g004819
1. Right hydraulic line
2. Hydraulic filter
1 fluid.
7. Apply a thin coat to the rubber gasket on the
® replacement filter
8. Install the replacement hydraulic filter onto the
filter adapter.
Note:
9. Fill the hydraulic tank with hydraulic fluid until
the fluid overflows the filter and then turn the
fluid filter clockwise until the rubber gasket
contacts the filter adapter, then tighten the filter
an additional 1/2 turn
10. Clean up any spilled fluid.
11. Add fluid to the cold level of the baffle in the
hydraulic tank.
12. Start the engine and let it run for about 2 minutes
to purge air from the system.
13. Shut off the engine and check for leaks.
67
Figure 95
(Figure 96).
96).
Figure 96
3. Hydraulic tank
(Figure 96).
Do not tighten.
(Figure
g001044
g001313
96).