Servicing The Fuses; Drive System Maintenance; Checking The Seat Belt; Adjusting The Tracking - Toro Z Master Professional 7000-Serie Bedienungsanleitung

Servicing the Fuses

The electrical system is protected by fuses. It requires
no maintenance, however, if a fuse blows check
component/circuit for malfunction or short.
1. Unlatch the engine hood and raise the engine
hood to gain access to fuse holder
2. To replace the fuses, pull out on the fuse to
remove it.
3. Install a new fuse
Figure 71
1. Ignition—30 A (F1)
2. Radiator fan—50 A (large,
heavy duty fuse)
(Figure
(Figure 71).
3. Clutch—10 A (F3)
4. Left fuel tank
Drive System
Maintenance

Checking the Seat Belt

71).
Service Interval: Before each use or daily
Inspect the seat belt for wear, cuts, and proper
operation of the retractor and buckle. Replace the
seat belt if it is damaged.

Adjusting the Tracking

The machine has a knob for adjusting the tracking
located under the seat.
Important:
hydraulic pump neutral before adjusting the
tracking; refer to
Neutral Position (page 65)
Hydraulic Pump Neutral Position (page
1. Disengage the blade-control switch (PTO).
2. Drive to an open flat area, move the
motion-control levers to the N
position.
3. Move the throttle midway between the F
S positions.
LOW
4. Push both control levers forward the same
g012492
distance.
5. Check which way the machine tracks.
6. Engage the parking brake, shut off the engine,
and remove the key.
7. Unlatch the seat and tilt the seat forward to
access the tracking knob.
8. Adjust the tracking knob as needed.
Note:
Determine the left and right sides of the
machine from the normal operating position.
•
If the machine tracks to the right, turn the
knob toward the left of the machine; refer to
Figure
•
If the machine tracks to the left, turn the
knob toward the right of the machine; refer
to Figure
9. Repeat adjustment until the tracking is correct.
54
Adjust the handle neutral and
Adjusting the Control Handle
and Setting the
EUTRAL
72.
72.
68).
-L
OCK
and
AST