Removing The Blades; Sharpening The Blades - Toro Z Master Professional 7000-Serie Bedienungsanleitung

Figure 104
1. Opposite blade edge (in position for measuring)
2. Level surface
3. Second measured distance between blade and surface (B)
A. If the difference between A and B is greater
than 3 mm (1/8 inch), replace the blade with
a new blade; refer to
(page 72) and
73).
Note:
If a bent blade is replaced with a
new blade, and the dimension obtained
continues to exceed 3 mm (1/8 inch), the
blade spindle could be bent. Contact an
Authorized Service Dealer for service.
B. If the variance is within constraints, move to
the next blade.
6. Repeat this procedure on each blade.

Removing the Blades

Replace the blades if they hit a solid object, or if the
blade is out of balance or bent.
1. Place a wrench on the flat of the spindle shaft or
hold the blade end using a rag or thickly padded
glove.
2. Remove the blade bolt, bushing, and blade from
the spindle shaft
Removing the Blades
Installing the Blades (page
(Figure 105).
g014973
1. Sail area of the blade
2. Blade
3. Flat of the spindle shaft

Sharpening the Blades

1. Use a file to sharpen the cutting edge at both
ends of the blade
Note:
Maintain the original angle.
Note:
The blade retains its balance if the same
amount of material is removed from both cutting
edges.
1. Sharpen at original angle.
2. Check the balance of the blade by putting it on
a blade balancer
Note:
If the blade stays in a horizontal position,
the blade is balanced and can be used.
Note:
If the blade is not balanced, file some
metal off the end of the sail area only
106).
72
Figure 105
4. Bushing
5. Blade bolt
(Figure 106).
Figure 106
(Figure 107).
(Figure
g295816
g000552