Toro Z Master Professional 7000-Serie Bedienungsanleitung Seite 71

4. Open the throttle to
Note:
Make sure that the wheel remains
stopped or slightly creeps in reverse; adjust if
necessary.
Figure 98
1. Tracking knob
2. Hydraulic tank
3. Hydraulic pumps
.
FAST
4. Turn this way to track right
5. Turn this way to track left
Setting the Left Hydraulic Pump
Neutral Position
1. Loosen the locknuts at the ball joints on the
pump control rod
2. Start the engine, open the throttle 1/2 way and
disengage parking brake; refer to
Engine in Normal Weather (page
Note:
The motion-control lever must be in
neutral while making any adjustments.
Note:
The front nut on the pump rod has
left-hand threads.
3. Adjust the pump rod length by rotating double
nuts on rod, in the appropriate direction, until
wheel is still or slightly creeps in reverse
99).
4. Move the motion-control lever forward and
reverse, then back to neutral. The wheel must
stop turning or slightly creep in reverse.
5. Open the throttle to fast. Make sure that the
wheel remains stopped or slightly creeps in
reverse, adjust if necessary.
6. Tighten the locknuts at the ball joints
g001070
1. Double nuts
2. Pump rod
3. Adjustment bolt
69
(Figure 99).
Starting the
26).
(Figure
Figure 99
4. Locknut
5. Ball joint
6. Pumps
(Figure
99).
g001066