Replacing The Pto-Drive Belt - Toro Z Master Professional 7000-Serie Bedienungsanleitung

Replacing the PTO-Drive
Belt
Service Interval: Every 50 hours—Check the
PTO-drive belt.
1. Park the machine on a level surface, disengage
the blade-control switch, and engage the parking
brake.
2. Shut off the engine, remove the key, and wait
for all moving parts to stop before leaving the
operating position.
3. Loosen the front engine panel knobs and
remove the panel
Figure 87
1. Knob
4. Remove the spring from the idler arm
88).
5. Remove the clutch stop bracket.
6. Remove the old PTO-drive belt.
7. Install the PTO-drive belt around the clutch
pulley and the gearbox pulley
8. Intall the rubber clutch stop.
9. Install the spring to the idler arm
(Figure 87).
2. Front engine panel
(Figure
(Figure 88).
(Figure 88).
1. Gearbox
2. Spring
3. Spring-loaded idler pulley
g001312
63
Figure 88
4. Clutch
5. Rubber clutch stop
6. PTO-drive belt
g007176