General Safety Rules For The Use; General Description - Telwin ALASKA 200 START Bedienungsanleitung

ENGLISH

1. GENERAL SAFETY RULES FOR THE USE........................................... 4

2. GENERAL DESCRIPTION ...................................................................... 4

3. CONTROL, ADJUSTMENT AND INDICATOR DEVICES ....................... 4
........................................................................... 4
4. INSTALLATION ........................................................................................ 4
5. OPERATION DURING CHARGING ......................................................... 5
1. GENERAL SAFETY RULES FOR THE USE
- During the charge the battery produces explosive gases,
- Position the batteries to be charged in a well-ventilated
place.
- Inexperience and untrained people should be
properly instructed before using the appliance.
- This appliance can be used by children aged from 8
years and above and persons with reduced physical, sensory
or mental capabilities or lack of experience and knowledge if
they have been given supervision or instruction concerning
use of the appliance in a safe way and understand the hazards
involved.
- Children shall not play with the appliance.
- Cleaning and user maintenance shall not be made by children
without supervision.
- Disconnect the mains cable before connecting to or disconnecting
the charging cables from the battery.
- Do not connect or disconnect the clamps to or from the battery with
the battery charger operating.
- Substitute the mains cable only with an original one.
order to avoid a hazard.
- Do not use the battery charger to charge batteries which are not
rechargeable.
shown on the battery charger rating plate.
the warnings given by the producer of the vehicle or the batteries
used.
garage or in a similar place set the battery charger in a suitable
case.
- WARNING: ALWAYS DISCONNECT THE POWER SUPPLY
CABLE FROM THE MAINS BEFORE CARRYING OUT ANY
SIMPLE MAINTENANCE OPERATION ON THE BATTERY
CHARGER.
is protected by an earth connection.
- For models supplied without plugs, connect plugs having a
capacitance suitable for the value of the fuse shown in the plate;
replacing the plug with one having a capacitance suitable for the
fuse shown in the plate.
2. GENERAL DESCRIPTION
2.1 AUTOMATIC BATTERY CHARGERS (TRONIC)
interruption and automatic restart) designed for charging sealed
.............................. 4
.......................... 4
............................................................... 4
....................................... 4
............................................ 4
................................................................ 5
INDEX
6. VEHICLE STARTING OPERATION ......................................................... 5
7. BATTERY CHARGER PROTECTION ..................................................... 5
8. USEFUL ADVICE ..................................................................................... 5
12V and 24V batteries.
3. CONTROL, ADJUSTMENT AND INDICATOR DEVICES
3.1 CHARGE LEVEL INDICATOR (AMMETER FIG. A)
During the charge phase, the charge level indicator moves from right
to left indicating a decrease in the current required by the battery
exact battery status can only be determined using a hydrometer,
monitor the ammeter to determine when the battery is fully charged
and needs to be disconnected from the battery charger to prevent
will move to the far right indicating the use of maximum current.
3.2 SETTING THE CHARGE MODE AND CHARGE CURRENT
(FIG. B)
position to help start the vehicle.
3.3 INDICATOR LEDS (FIG. C)
connected to the battery with the poles inverted.
them to the battery correctly.
turns green when the charge phase is completed.
4. INSTALLATION
4.1 POSITIONING THE BATTERY CHARGER
During operation, position the battery charger on a stable surface
4.2 CONNECTION TO THE MAIN SUPPLY
to a power source with the neutral lead connected to earth.
equipment.
absorption of the equipment.
cable.
be adequate and, in any case, never less than that of the cable
supplied.
- You always have to earth the equipment with the yellow/green wire
other two wires should be connected to the phase and the neutral
- 4 -
............................. 5
................................... 5
.............................. 5
............................................................................ 5
............................. 5
.................................................................. 5
.......................................................................... 5
............... 5
.............. 5
), while the