Useful Advice - Telwin ALASKA 200 START Bedienungsanleitung

cable.
5. OPERATION DURING CHARGING
NB: Before charging check that the capacity of the battery (Ah)
which is to be charged, is not inferior to that reported on the
data table of the battery charger (C min). Follow the instructions,
taking great care to respect the order given below.
5.1 BATTERY PREPARATION
water and cover them up to 5-10 mm.
WARNING: USE THE MAXIMUM CAUTION DURING
THIS OPERATION AS THE ELECTROLYTE IS A HIGHLY
CORROSIVE ACID.
5.2 BATTERY CHARGER/BATTERY CONNECTION
with the selected charge voltage.
- Connect the red charge clamp to the positive terminal of the battery
positive terminal is the one not connected to the vehicle chassis.
distance from the battery and the fuel pipe.
NOTE: if the battery is not installed in the vehicle, connect the clamp
5.3 MANUAL CHARGE AND AUTOMATIC CHARGE MODES
5.3.1 MANUAL CHARGE (CHARGE) MODE
- Follow the instructions provided in paragraphs 5.1 and 5.2 carefully.
- Power the battery charger by inserting the power cable into the
- Monitor the charge indicator as described in paragraph 3.1.
NOTE:
soon as this happens to prevent damage to the battery.
5.3.2 AUTOMATIC CHARGE (TRONIC) MODE
- Follow the instructions provided in paragraphs 5.1 and 5.2 carefully.
- Power the battery charger by inserting the power cable into the
battery ends and automatically disconnects the current supply
5.4 SIMULTANEOUS CHARGING OF MULTIPLE BATTERIES
WARNING: do not simultaneously charge batteries of different
D).
For "parallel" connections the batteries must have the same rated
charger.
For "series" connections the batteries must have the same capacity
correspond to the output rated voltage supplied by the battery
charger.
5.5 CHARGE ENDING
- Disconnect the power to the battery charger moving the switch to
- Disconnect the red charging clamp from the positive battery
6. VEHICLE STARTING OPERATION
WARNING: Before proceeding, read the vehicle manufacturers
instructions carefully!
) symbol.
minutes at maximum level before starting.
could cause serious damage to the battery or even to the electrical
but wait a few minutes and then repeat the rapid charge operation.
6.1 BATTERY CHARGER/BATTERY CONNECTION
battery charger clamps as described in paragraph 5.2.
from their respective terminals; the presence of the battery is
essential for the elimination of possible overvoltage.
6.2 STARTING WITH START
the mains.
the engine.
6.3 END OF STARTING
- Disconnect the power to the battery charger by turning the switch
- Store the battery charger in a dry place.
7. BATTERY CHARGER PROTECTION
- Polarity inversion on the battery clamps.
WARNING:
shown on the rating plate it could cause damage to people or
property. For the same reason, never ever replace the fuse with a
bridge in copper or other material.
mains supply while the fuse is being changed.

8. USEFUL ADVICE

clean them to ensure good contacts with the clamps.
blow.
is permanently installed in the vehicle, also consult the vehicle
- 5 -