(En); Introduction And General Description - Telwin 954854 Bedienungsanleitung

INSTRUCTION MANUAL
WARNING: BEFORE USING THE BATTERY
CHARGER READ THE INSTRUCTION MANUAL
CAREFULLY.
1. GENERAL SAFETY RULES WHEN USING
THIS BATTERY CHARGER
- During the charge the battery produces
explosive gases, avoid the formation of flames
and sparkes. DO NOT SMOKE.
- Position the batteries to be charged in a well-
ventilated place.
- Inexperience and untrained people should
be properly instructed before using the
appliance.
- This appliance can be used by children
aged from 8 years and above and persons
with reduced physical, sensory or mental
capabilities or lack of experience and
knowledge if they have been given
supervision or instruction concerning
use of the appliance in a safe way and
understand the hazards involved.
- Children shall not play with the appliance.
- Cleaning and user maintenance shall not
be made by children without supervision.
- Disconnect the
connecting to or disconnecting the charging
cables from the battery.
- Do not connect or disconnect the clamps to
or from the battery with the battery charger
operating.
- Never use the battery charger inside the car or
in the bonnet.
- Substitute the mains cable only with an
original one.
- If the supply cord is damaged, it must be
replaced by the manufacturer, its service
agent or similarly qualified persons in order to
avoid a hazard.
- Do not use the battery charger to charge
batteries which are not rechargeable.
- Make sure the available power supply voltage
corresponds to that shown on the battery
charger rating plate.
- To avoid damaging the vehicle's electronics,
read, keep and take very careful note of
the information supplied by the vehicle
manufacturer, when using the battery
charger either for charging or starting; the
same applies to the instructions supplied by
the battery manufacturer.
- This battery charger has components such as
switches and relays which can cause arcs or
sparks. Therefore when using it in a garage or
in a similar place set the battery charger in a
suitable case.
- Repair or maintenance of the inside of the
battery charger can be executed only by
skilled technicians.
- ALWAYS DISCONNECT THE POWER
SUPPLY CABLE FROM THE MAINS
BEFORE
INTERVENTION
CHARGER.

(EN)

mains cable
ANY MAINTENANCE
ON THE BATTERY
2. INTRODUCTION
DESCRIPTION
- This battery charger is used to charge
electrolyte free lead batteries, sealed batteries
and lithium batteries used on motor vehicles
(petrol and diesel), motorcycles, boats etc.
- Rechargeable accumulators according to the
output voltage available: 6V lead / 3 cells; 12V
lead / 6 cells; 24V lead / 12 cells; 12V and 24V
lithium.
- This battery charger, according to the model,
can have a power supply of 230V 50/60Hz or
110V 50/60Hz (according to the plate data)
mono-phase.
The charge voltage and current supplied by
the device are electrically controlled and have
an IU or U charge curve.
- Standard features:
- The device allows you to connect different
types of output cables for the charging of
batteries:
- cables fitted with eyelets (fig. B-1);
- cables fitted with clamps (fig. B-2).
3. DESCRIPTION OF THE BATTERY CHARGER
Control, adjustment and indicator devices.
3.1 LCD version battery charger
Charge voltage.
Using the button in fig. A-1 you can set one of
the following functions, charging or test, in
succession:
PULSE TRONIC charge functions
6V
before
6V GEL
6V AGM
6V AGM+
6V EFB
6V Li
6V
(where planned)
TEST functions
•
•
•
•
•
•
•
•
•
In any PULSE - TRONIC mode, pressing the
key in fig. A-1 for 3 seconds you set one of the
- 4 -
AND
12V 24V
12V GEL 24V GEL
12V AGM 24V AGM
12V AGM+ 24V AGM+
12V EFB 24V EFB
12V Li 24V Li
12V 24V
(where planned)
6V
: Battery Test
6V
: Starting Test
6V
: Alternator test
(where planned)
12V
: Battery Test
12V
: Starting Test
12V
: Alternator test
24V
: Battery Test
24V
: Starting Test
24V
: Alternator test
(where planned)
GENERAL