Page EN-14
Assembly
7. Fold the cover (7) down.
For exhaust air operation
(11)
)
(12)
1. Insert the two wings of the check valve (3)
using the pins (10) into the mounting holes
(11) of the exhaust port (12).
Gently bend the wings a little so as not to
break off the sensitive plastic noses.
2. Only in an underframe under a cabinet
element:
Mark the air outlet opening for the exhaust
air hose (2) at the bottom of the cabinet.
(7)
Drill a hole inside the circle with a wood drill.
Starting from there, saw out the circle using
a jigsaw.
Smooth the edges with sandpaper.
(2)
(12)
(10)
3. Place the exhaust air hose (2) with the
153 mm diameter opening onto the ex-
haust air opening (12).
(3)
4. Secure the drain hose with the cable
tie (4).