Preparatory Steps - Athena GET 2ND INJ. KIT Installationsanleitungen

The GET 2nd INJECTOR KIT has been developed to increase the
engine performance and supporting the stock injector. The kit
works only with GET ECUs that are "2nd Injector Ready".
MAIN GET 2nd INJECTOR KIT FEATURES:
• Power maximization
Installing a second injector allows a huge power increase. The
difference is real especially on medium and high revs.
• Injection optimization
GET kit ensures a higher power output, an improved fuel flow and
a better throttle response as well.
• Engineered and tested in GET laboratories
The kit and the maps are developed for your specific machine.
GET technicians study the OEM engine and components, design
and define the second injector position. Strict quality tests are
performed then both on dyno and on track.
C. PREPARATORY STEPS
KEEP THE ENGINE TURNED OFF AND REMEMBER TO
WORK UNDER SAFETY CONDITIONS.
MANIFOLD
1. Remove the seat, the fuel tank, the exhaust, the rear subframe,
and all the other components to pull out the manifold. Check on your
motorbike's workshop manual where to find these components.
2. Remove the upper engine mount brackets to allow access to
the ECU and ease the following steps.
3. Place the jig included in the box on the bottom side of the
manifold and use it as a template.
ATTENTION: There are 2 symbols printed on the jig
indicating their direct references on the manifold.
Make sure symbols and references are aligned and
mark the points indicated by the three holes.
EN 4
USE THE JIG AS A TEMPLATE, DO NOT USE IT AS A SUPPORT
FOR MILLING. DO NOT USE DRILL BITS, ONLY USE MILLING
MACHINE BITS. REMEMBER TO REMOVE ANY RESIDUE
LEFT FROM THE MILLING: THE RESIDUES CAN DAMAGE
THE ENGINE OR AFFECT ITS PERFORMANCE.
4. Remove the jig and mill the three holes.
FUEL HOSES
1. Find the OEM fuel hose. Check on your motorbike's workshop
manual where to find it. Remove the OEM fuel hose and cut off
the couplings with a cutter. The OEM fuel hose will not be used.
ATTENTION:
DO NOT DAMAGE THE OEM FUEL COUPLINGS.
2. Cut GET fuel hose by following these measures:
A (OEM injector side) = 190 mm / 7.48"
B (GET second injector side) = 380 mm / 14.96"
C (fuel pump side) = 230 mm / 9.06"
3. Install the OEM Couplings on the ends of GET fuel hose chunks
fixing them with the provided hose clamps as follows:
- OEM injector coupling on hose A
- OEM fuel pump coupling on hose C
gk-inj2-0014
190 mm / 7.48" 380 mm / 14.96"
To OEM injector To GET 2nd injector
A B
4. Connect the hoses A, B and C with the 3-way fitting included in
the kit and fix everything with hose clamps.
230 mm / 9.06"
To the fuel pump
C
5 EN